Serious Steel
911101
SPOTTER STAND ATTACHMENT
ASSEMBLY INSTRUCTIONS
Part # 6639501
ParaBody, Incorporated
14150 Sunfish Lake Boulevard
Ramsey, MN 55303
1-800-328-9714
1
Revision: 06/10196
911101
SPOTTER STAND ATTACHMENT ASSEMBLY PARTS ]LIST
SORT AND COUNT ALL PARTS BEFORE BEGINNING ASSEMBLY
HARDWARE:
ITEM NAME/DESCRIPTION QTY
1/2 X 3-1/4 IN BOLT ..........................................................................................................
3 X 2 INEND CAP .............................................................................................................
2
2
WELDMENTS/PARTS:
ITEM NAME/DESCRIPTION
NOTE: BOLT LENGTH IS MEASURED FROM ~ UNDERSIDE OF THE I:I~AD OF ’rE[:E BOLT.
BOLT LENGTH
BOLT LENGTH RULER:’,
0 1
2 [ I I I
4
5 6
QTY
Part # 6639501
2
Revision: 06,/10/96
911101 SPOTTER STAND ATTACHMENT ASSEMBLY INSTRLICTIONS
Loosen and remove hardware that attaches the BENCH FRAME WELDMENT to the LOWER
CROSS SUPI[’ORT of the UPRIGHT FRAME WELDMENT.
Insert two (2) 3 X 2 IN END CAPS into the ends of the SPOTTER STAND ATTACHMENT as shown
on drawing.
SECURELY assemble the SPOTTER STAND ATTACHMENT to the LOWER CROSS SUPPORT
of the UPRIGHT FRAME WELDMENT using the two 1/2 X 3-1/4 IN REPLACEMENT BOLTS, and
the two (2) existing 1/2 IN LOCK NUTS as shown on drawing. (THE 1/2 IN WASHEI~; ARE
NEEDED FOR THIS ASSEMBLY)
Part # 6639501
3
Revision: 06/10/96
Loading...