Panasonic WINDB-M1 installation
Panasonic Corporation of North America
1690 Roberts Blvd., NW, Suite 110
Kennesaw, GA 30144
Tel: 770.977.8510
INSTALLATION INSTRUCTIONS
Panasonic Universal Wind Shield (Baffle) Part Number: WINDB-M1
CONTENTS INCLUDED: 2 side panels, 1 top panel, 2 back panels, 8 sheet metal screws, 8 washers, 8 spacers, 24
screws, 24 locknuts and 24 shoulder spacers.
GENERAL: This wind shield is sized so it will fit onto the rear (Coil Side) of a Panasonic outdoor mini split unit with
model numbers CU-2E18, CU-3E19, RKUA-18, RKUA-24, RE18SKUA, RE24SKUA, E18SD3UA
INSTALLATION PROCEDURES:
Remove all the protective film on the clear parts. Pre assemble all parts (Fig 1 and Fig 2).
BEFORE DRILLING OR SCREWING INTO THE UNIT, MAKE SURE THERE WILL BE NO CONTACT WITH REFRIGERANT
TUBING OR ELECTRICAL WIRES. CHECK FOR CLEARANCE.
Fasten the assembled wind baffle to the unit using the provided drill tip screws, nylon spacers and washers (Fig 3).
Note that the top of the baffle will be about 4 in + - above the top of the unit. This will give the unit extra protection
from wind and hail.
Unit
Nylon Spacer
Clear Part
FIG. 3
Unit
Stainless Steel Washer
Drill Tip Screw
FIG. 1
Outer or Top Part
Lock Nut
Caution: Do not over tighten lock
Nut. Tighten nut until slightly
snug, then back off until it will
lightly twist or spin.
Screw
Shoulder Spacer
Inner or Under Part
FIG. 2
Caution: Use only mild soap or detergent and water to clean baffle. Do not use any chemicals
Loading...