Dear Panasonic Customer,
Welcome to the Panasonic family of customers. We hope that you have many years of enjoyment from your new colour television.
The best way to understand the features of this television is to read this book thoroughly, before operating the set.
This television has a low power consumption making it very cost effective to run.
To this end, the standby power consumption is merely 1 watt.
CONTENTS
DWarnings and Precautions3...................
DAccessories4................................
DFitting Remote Control Batteries4..............
DInstallation and Set---up5......................
DLocation of Controls7.........................
DMenu Operation8............................
DTeletext Operation12..........................
DAudio / Video Connections13...................
DVCR Installation14............................
DVCR Operation15.............................
DTrouble---shooting16..........................
DGeneral Information16.........................
2
DSpecifications17.............................
DScart Terminal Information17...................
WARNINGS AND PRECAUTIONS
DThis T.V. is designed to operate on A.C. 220 --- 240V,50Hz
and is capable of receiving the PAL I transmission
standard.
DDo not expose this TV set to rain or excessive moisture.
DWARNING: HIGH VOLTAGE !
Do not remove the rear cover, there are no user
serviceable parts inside.
DAvoid exposing the TV set to direct sunlight or other
sources of heat.
DRemove the mains plug from the wall socket when the TV
set is not to be used for a prolonged period of time. Do not
pull the power cable to remove the mains plug from the
socket, always remove it by the plug.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING CAREFULLY
This appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. If
the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI markon the body of the fuse.
DCABINET AND PICTURE TUBE CARE
Remove the mains plug from the wall socket. The cabinet
and picture tube can be cleaned with a soft cloth
moistened with mild detergent and water. Do not use
solutions containing benzol or petroleum. TV sets can
produce static electricity, care must be taken whenever
touching the TV screen.
DAdequate ventilation is essential to prevent failure of
electrical components. We recommend that a gap of at
least 5cm is left all around this TV even when it is placed
inside a cabinet or between shelves.
If the fitted plug has a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained.
Replacement fuse covers can be purchased through your local Panasonic dealer.
Theplugfittedtothisapplianceincorporates a mains filter circuit. If this is removed or
replaced with a non--- filtered mains plug this television will no longer meet the
European standards f or Electromagnetic Compatibility (EMC). If the fitted plug is
unsuitable for the socket outlet in your home an appropriate adapter should be used.
Nonetheless,ifthefittedplugisreplaced,thefuseshouldbetakenoutandthecut---off
plug disposed of safely. There is danger of severe electrical shock if the cut off plug is
inserted into any 13amp socket.
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
How to replace the fuse :
Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit
securely into the mains plug.
IMPORTANT : ---
As the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your plug,
proceed as follows : ---
1.The BLUE
2.The BROWN
The wires in the mains lead of this appliance are coloured in accordance with the following code : ---
BLUE : NEUTRALBROWN : LIVE
wire must be connected to the terminal marked ‘N’ or coloured black.
wire must be connected to the terminal marked ‘L’ or coloured red.
Important Note :
The layout of the mains plug used
may differ from this illustration.
IMPORTANT NOTE : Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug,
marked with the l etter ‘E’ or the earth symbol ().
3
ACCESSORIES
Check that you have the accessories and items shown
Remote Control
Transmitter EUR511300
Operating Instruction book
TQB8E3019---2
Questionnaire
T. V. S t a n d
TS---2800 (TX --- 21JT1)
TV Guarantee
Colour
Tube
CRT Guarantee
TSA8E001 (TX --- 14JT1)
AV cover
TKK8E043
( T X --- 2 1 J T 1 )
Batteries for the
Remote Control Transmitter.
(2 x R6 (UM3) size)
Loop Antenna
FITTING REMOTE CONTROL BATTERIES
1
Slide off the battery cover
D Make sure that the batteries are fitted the correct way round.
D Do not mix old batteries with new batteries. Remove old, exhausted batteries immediately.
23
Insert batteries -- note correct
polarity (+ and -- )
Replace the cover
D Do not mix different battery types, i.e. Alkaline and Manganese. Do not use rechargeable (Ni---Cad) batteries.
4
INSTALLATION AND SET---UP
Mains
Socket
1
TV only
Connect Aerial co---axial cable direct to TV RF IN
socket.
OR
VCR
Mains
Socket
Mains
Socket
USING A VCR
Connect aerial co--- axial cable to RF Input socket
of VCR and a RF co---axial cable from VCR RF
OutsockettoTVRFINsocket.
Connect aerial co--- axial cable to RF Input socket
of VCR.
A further co--- axial cable connects from the VCR
RF OUT socket to the TV RF IN socket.
The Satellite Receiver and VCR must be linked
by SCART to SCART lead.
SATELLITE RECEIVER
Further information for VCR and Satellite Rece iver
installation with this TV can be found on page 14.
VCR
Ancillary equipment and leads are not supplied.
5
INSTALLATION AND SET---UP
23
Switch ON your VCR (if connected).
Switch ON your Satellite Receiver (if connected).*
1
Plug the TV into a mains socket and switch ON.
Programmes will appear immediately if your
dealer has already tuned the TV for you.
Volume adjust
4
The first available channel will be displayed.
1
CH41
If the TV has not been tuned for you then
Auto setup will begin. TV stations will be
located, sorted and stored.*
CH21
Auto Setup
2169
2
Programme change
BBC1 CEEFAX
*1.If you have an analogue satellite receiver, select ’Sky One’ or ’Sky News’ before starting Auto Setup. If you have a digital satellite
receiver, you can start Auto Setup with the receiver set to any channel. If, after Auto Setup is complete, the programme position of
the digital satellite receiver is not to your preference, you can re---arrange the programme position with the Swap feature. (See
page 11 for details.)
*2.The sorting order depends upon the TV signal, the broadcasting system, and reception conditions. If either BBC1, BBC2 or ITV
are not located, then their respective pre --- allocated programme positions (1 to 3) will remain unused.
Note :
~ The next available channel will appear, if no other stations are available then the Programme position will remain unused.
Channel 5 and the Satellite channel are pre --- allocated to programme positions 6 and 7 respectively.
If the order is not to your preference it can be rearranged. Refer to the Tuning menu Swap feature --- see page 11 for details.
IT IS IMPORTANT that you only use TV programme position ‘0’ to view your VCR. If your VCR picture does not appear on
programme position ‘0’ (the VCR position), it will be necessary to either adjust the RF channel of the VCR (refer to your VCR
operating instructions) or to adjust the tuning of the TV’s programme position ‘0’ or both until the RF output channel of the VCR is
received, refer to page 14 for guidance.
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.