Panasonic PT-VX605N Technical data

PEC

SFL14M025

ILE

Product Number :

Product Name :

PT-VX605N

LCD Projectors

As of August 2014. Specifications and appearance are subject to change without notice.

1/12

PT-VX605N

LCD Projectors

SFL14M025

Specifications

Main unit

Power supply

Power consumption

LCDpanel Panel size

Lens

Throw ratio Lamp Screen size Colors Brightness*

Center-to-corner uniformity* Contrast*

Resolution

Scanning frequencyHDMI

Optical axis shift Keystone correction range

Installation Built-in speaker Size

AC 120 V, 50/60 Hz AC 110 V, 60 Hz (Taiwan), AC 100–240 V, 50/60 Hz (other countries) 363 W (North America), 369 W (Taiwan), 369 W (other countries)

0.2 W when STANDBY MODE set to ECO*

0.4 W when STANDBY MODE set to ECO* 14 W when (18 W when a HDBaseT™ device is connected, 30 W at rated audio output while an HDBaseT™ device is connected.)

16.0 mm (0.63 inches) diagonal (4:3 aspect ratio) Display method Drive method Pixels

Transparent LCD panel (× 3, R/G/B) Active matrix method 786,432 (1,024 × 768) ×3, total of 2,359,296 pixels Manual zoom (1.6×), manual focus, F 1.60 – 1.90, f 15.31–24.64 mm

1.2–1.9:1

270 W UHM lamp

0.76–7.62 m (30–300 inches) diagonally, 4:3 aspect ratio

Full color (16,777,216 colors)

5,500 lumens (Input signals: PC, Lamp power: Normal, Picture mode: Dynamic)

85% 1,0000:1 (full on/off, Picture mode: Dynamic, Iris: on) XGA 1,024 × 768 pixels (Input signals that exceed this resolution will be converted to 1,024 × 768 pixels.) 480i (525i)*

720 (750)/50p, 1080 (1125)/60i, 1080 (1125)/50i, 1080 (1125)/25p, 1080 (1125)/24p, 1080 (1125)/24sF, 1080 (1125)/30p, 1080 (1125)/60p, 1080 (1125)/50p VGA (640 ×480)–WUXGA (1,920 ×1,200), VESA CVT-RB compliant

dot clock: 25 –162 MHz, HDCP compatible RGB YP

BPR (YCBCR )

H: 15 – 91 kHz, f V: 24 – 100 Hz, dot clock: 162 MHz or lower

480i (525i):

576i (625i):

480p (525p):

576p (625p):

720 (750)/60p:

720 (750)/50p:

1080 (1125)/60i:

1080 (1125)/50i:

1080 (1125)/25p:

1080 (1125)/24p:

1080 (1125)/24sF:

1080 (1125)/30p:

1080 (1125)/60p:

1080 (1125)/50p:

Video/S-Video

H: 15.73 kHz/15.63 kHz, fV: 59.94 Hz/50 Hz

[NTSC/NTSC4.43/PAL/PA L60/PAL-N/PAL-M/SECAM]

Vertical 0 – +40% from center of screen (manual), U/D ratio on top end: 9:1

Vertical: maximum ±35° (auto/manual, input: XGA),

Horizontal: maximum ±35° (manual, input: XGA)

Ceiling/desk, front/rear

4 cm (1-9/16 inches) (round) ×1 Output power

10 W (monaural)

(North America),

(Taiwan),

(other countries)

STANDBYMODE set to NORMAL

Input signals: PC, Lamp power: Normal,

, 576i (625i)*3, 480p (525p), 576p (625p), 720 (750)/60p,

fH15.73 kHz; fV59.94 Hz, fH15.63 kHz; fV50 Hz, fH31.47 kHz; fV59.94 Hz,

H 31.25 kHz; fV 50 Hz,

f fH45.00 kHz; fV60 Hz, fH

37.50 kHz; fV50 Hz,

33.75 kHz; fV60 Hz,

H H 28.13 kHz; fV 50 Hz,

f fH 28.13 kHz; fV 25 Hz, f

27.00 kHz; fV24 Hz,

27.00 kHz; fV48 Hz,

33.75 kHz; fV30 Hz,

f f

67.50 kHz; fV60 Hz,

fH56.25 kHz; fV50 Hz

As of August 2014 2/12

PT-VX605N

LCD Projectors

SFL14M025

Terminals HDMI IN HDMI 19-pin ×2, Deep Color, HDCP compatible

Power cord length

Cabinet materials Dimensions (W ×H×D)

Weight* Operation noise* Operating temperature

Operating humidity

Audio signals: Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz) COMPUTER 1IN

R, G, B

Y, P

B (CB), PR (CR)

S-VIDEO Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms

COMPUTER 2IN / 1 OUT

R, G, B

B (CB), PR (CR)

Y, P

VIDEO IN AUDIO IN 1 AUDIO IN 2 / MIC IN M3 (L, R) × 1, 0.5 Vrms, input impedance: 22 kilohms or more AUDIO IN 3 AUDIO OUT

SERIAL IN DIGITAL LINK / LAN RJ-45 × 1, for network connection/DIGITAL LINK, 100BASE-TX,

USB AUSB type-A (for the Memory Viewer) × 1 USB BUSB type-B (for the USB Display) × 1

D-sub HD 15-pin (female)

×1 G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms; B, R: 0.7 Vp-p, 75 ohms; HD/SYNC TTL high impedance, automatic positive/negative polarity compatible

VD TTL high impedance, automatic positive/negative polarity compatible Y: 1.0 Vp-p (including sync signal); PB (CB), PR (CR): 0.7 Vp-p, 75 ohms

D-sub HD 15-pin (female) × 1, (input/output switching) G: 0.7 Vp-p (1.0 Vp-p for sync on G), 75 ohms; B, R: 0.7 Vp-p, 75 ohms; HD/SYNC TTL high impedance, automatic positive/negative polarity compatible

VD TTL high impedance, automatic positive/negative polarity compatible Y: 1.0 Vp-p (including sync signal);

PB (CB), PR (CR): 0.7 Vp-p, 75 ohms Pin jack ×1, 1.0 Vp-p, 75 ohms M3 (L, R) × 1, 0.5 Vrms, input impedance: 22 kilohms or more

Pin jack (L, R) × 1, 0.5 Vrms, input impedance: 22 kilohms or more M3 (L, R) ×1 (monitor out, stereo) 0–2.0 Vrms, variable, output impedance: 22 kilohms or less D-sub 9-pin (female) ×1, for external control (RS-232C compliant)

compliant with PJLink™)

2.0 m* (6 ft 7 in) *PT-VX605ND(for India) : 3.0 m (9 ft 10 in) Molded plastic 389× 125*

× 332*5mm (15-5/16 × 4-29/32*4× 13-1/16*5inches) Approx. 4.9 kg (10.8 lbs) 37 dB (LAMP POWER: NORMAL), 29 dB (LAMP POWER: ECO) 0–40 °C (32–104 °F) (altitude: less than 1200 m) 0–30 °C (32–86 °F) (altitude: 1,200 m–2,700 m) * When the ambient operating temperature is 35–40 °C (95–104 °F),

[Lamp Power] will switch automatically to [Eco mode].

20%–80% (no condensation)

Remote control unit

Power supply Operation range*

3 V DC (R03/LR03/AAA type battery × 2) Approx. 7 m (23 ft) when operated from directly in front of the signal receptor

Dimensions (W × H × D) Weight

48 x 145 x 27 mm (1-7/8" x 5-23/32" x 1/16") Approx. 102g (3.60 ozs.)(including batteries)

Wireless LAN

Standard Modulation Transmission speed*

IEEE 802.11b IEEE 802.11g/a

IEEE 802.11n Operating range* Frequency range

IEEE802.11a/n

IEEE802.11b/g/n Security Infrastructure mode

IEEE 802.11a/b/g/n DBPSK, DQPSK, CCK, BPSK, QPSK, 16QAM, 64QAM, MIMO Up to 11 Mbps Up to 54 Mbps Up to 300 Mbps Approx. 30 m (98 ft 5 in)

5.18–5.85 GHz

2.4GHz WPA-PSK (TKIP/AES), WPA2-PSK (TKIP/AES), WEP (128 bit/64 bit), WPA-EAP/WPA2-EAP (PEAP [MS-CHAPv2/GTC], EAP-FAST [MS-CHAPv2/GTC], EAP-TTLS [MD5/MS-CHAPv2]

As of August 2014 3/12

PT-VX605N

LCD Projectors

SFL14M025

Wireless Manager ME 6.2 system requirements

Web browser

CPU

Memory Free hard disk space CD-ROM drive Wireless LAN

Wired LAN connector

To use network functions, a PC is required that meets the conditions given below. Microsoft

Windows Vista®:Ultimate 32-bit/64-bit, Business 32-bit/64-bit, Home

Premium 32-bit/64-bit, Home Basic 32-bit/64-bit

Windows®7: Ultimate 32-bit/64-bit, Professional 32-bit/64-bit,

Home Premium 32-bit/64-bit

Windows

8 Pro 32-bit/64-bit,

Windows® 8 32-bit/64-bit

Windows

8.1: Windows® 8.1 32-bit/64-bit, Windows® 8.1 Pro 32-bit/64-bit

Apple Mac OS X*

: v10.6, v10.7, v10.8, v10.9 Windows®: Internet Explorer 7.0/8.0/9.0/10.0/11.0 Mac OS: Safari 3.0/4.0/5.0/6.0/7.0 Intel® Core™ i5 or higher, or other compatible processor

1024 MB or more 100 MB or more CD-ROM drive or DVD drive (required for installation) IEEE 802.11b/g/n compatible (built-in wireless LAN system or external IEEE 802.11b/g/n LAN card must be installed and running normally.)

NOTE: Wireless connection may not be possible with some IEEE 802.11b/g/n wireless

LAN systems. Macintosh computers must have a built-in wireless LAN adapter. For IEEE 802.11n connection, use a wire less LAN adapter, projector and access point that are IEEE 802.11n compatible, and connect with Infrastructure m ode.

5 (10BASE-T/100BASE-TX/1000BASE-T)4-JR

Supplied accessories

Wireless remote control unit (× 1) Power cord (2 m*) (× 1)

*PT-VX605ND(for India) : 3.0 m

Software CD-ROM (Operating instructions, Wireless Manager ME 6.2, Multi Projector Monitoring and Control Software, Logo Transfer Software) (× 1) Batteries for remote control (R03/LR03/AAA type× 2) Computer cable (1.8 m) (× 1) Lens cap (x 1)

Optional accessories

Digital interface box ET-YFB100G Easy Wireless Stick Ceiling mount bracket Ceiling mount bracket Projector Mount Bracket Replacement lamp unit Replacement filter unit Early Warning Software

D-SUB - S Video conversion cable

Weights and dimensions shown are approximate. Specifications subject to change without notice.

1When the Standby mode is set to Eco, network functions such as power on over the LAN network will not operate. Also, only certain com-

mands can be received for external control using the serial terminal.

2Measurement, measuring conditions, and method of notation all comply with ISO 21118 international standards.

3 Only compatible with dot clock frequency of 27 MHz (pixel repetition signal)

4With legs at shortest position.

5 Include protruding parts.

6 Average value. May differ depending on models.

7Operation range differs depending on environments.

8This is a theoretical speed. The actual transfer speed varies depending on the usage environment and connected devices.

9 The operation system must be pre-installed at the factory or clean installed.

10 The ET-UW100 is available in the following countries and regions as of May 2014: North America, England, Germany, France,Spain, Italy,

Belgium, Austria, Sweden, Norway, Denmark, Switzerland, Holland, Finland, Portugal, Greece, and Australia.

ET-UW100* ET-PKL100H (for high ceilings) ET-PKL100S (for low ceilings) ET-PKV400B ET-LAV400 ET-RFV400 ET-SWA100 ET-ADSV

As of August 2014 4/12

+ 8 hidden pages