MICROWAVE OVEN
TRIM KIT INSTALLATION DIAGRAMS
MODEL: NN-TK612GSQP (Stainless Steel)
Suitable for Microwave Oven Models:
NN-ST655WQPQ, NN-ST665BQPQ, NN-ST671SQPQ, NN-SD691SQPQ, NN-GD682SQPQ, NN-ST663WQPQ
410 mm
Microwave ovens should not be built into a unit directly above a top front
venting conventional cooker. This will invalidate your one year guarantee.
1. This trim kit can be installed into a cabinet. The cabinet opening must
have the following internal dimensions as shown. A vent is required at the
rear of the cabinet it should travel the full height of the cabinet and the
cabinet should not be obstructed. Minimum dimension of vent
45 mm x 562 mm.
MINIMUM INSTALLATION HEIGHT 850 MM.
2. Electrical Connections
The appliance is supplied with a mains plug attached and should only be
connected into an earthed socket that has been installed according to the
relevant safety regulations.
If the plug is no longer accessible after the appliance has been built into the
cabinet, a dual pole isolator must be installed to conform to the relevant
safety standards.
3. It is essential that the cabinet is fixed to the wall for stability. The shelf
must be able to support a weight of 30 kg.
4. If the microwave oven is to be removed from the kitchen cabinet and used
free standing, the built in parts must be removed, and the oven returned to its
original condition. Keep these installation instructions for future
reference so the installation process can be reversed.
min 45 mm
562
395 ± 2 mm
+ 8 mm
0 mm
596 mm
min 525 mm
min 45 mm
min 850 mm
TAKE CARE NOT TO KINK OR TRAP THE MICROWAVE ELECTRICAL CABLE.
The diagram may vary from the actual unit and is only for your reference.
NOTES:
1. Diagrams are not to scale.
2. Specifications are subject to change without notice. Publish date: March 2017.
Model No
NN-TK612GSQP
Trim Kits
Cabinet Opening Dimensions
H (mm) W (mm) D (mm) H (mm) W (mm)
395 562 525 410 596
Trim Kit Outside
Dimensions
www.panasonic.com.au