Panasonic KX-TGA290, KX-TGA290B User Manual
2.4 GHz Expandable Cordless Handset
)
Model No.
KX-TGA290
Installation Manual
PLEASE READ BEFORE USE AND SAVE.
This handset is an accessory cordless handset, for use with Panasonic base unit
KX-TG2970. This installation manual only describes the steps necessary to start up the
handset. Please read the base unit operating instructions for further details.
Accessories (included) For extra orders, call 1-800-332-5368.
A Charger Unit . . . . . . . . . . . . . . . . . . . . . . . . .1
Charger Order No. PQLV30028ZB
AC Adaptor Order No. KX-TCA1-G (KX-TCA1)
A Handset Cover. . . . . . . . . . . . . . . . . . . . . . . .1
Order No. PQYNTG2970BR
Installation
Connecting the Charger unit
AC Adaptor
CHARGE
A Battery . . . . . . . . . . . . . . . . . . .1
Order No. HHR-P402
A Belt Clip . . . . . . . . . . . . . . . . . .1
Order No. PQKE10340Z2
Power Outlet
(AC 120 V, 60 Hz
• USE ONLY WITH Panasonic AC ADAPTOR KX-TCA1 (Order No. KX-TCA1-G).
• The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel
warm during use.)
• The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet.
Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the
adaptor may cause it to become disconnected.
Installing the battery
Insert the battery (1), and press it down until it snaps into the compartment (2).
Close the cover.
2
1
For assistance, please call: 1-800-ADT-ASAP
– 1 –
PQQX14266ZA S0804-1094
Charging the battery
Place the cordless handset on the charger and
charge for 6 hours before initial use.
• The unit beeps once, the CHARGE indicator lights
and “Charging” is displayed.
• When the battery is fully charged, “Charge
completed” is displayed if there are no new calls in
the Caller List.
• Recharge the battery when:
—“Recharge battery” is displayed on the
cordless handset,
3” flashes, or
—“
— the cordless handset beeps intermittently while it
is in use.
• If the battery has been discharged, the cordless handset will display “Charge for 6
HRS” and “
handset will not work unless the battery is charged. Continue charging.
4” when you place the cordless handset on the charger. The cordless
Charge
Contacts
CHARGE
Indicator
Handset battery information
After your Panasonic battery is fully charged, you can expect the following performance:
Operation Operating time
While in use (TALK) Up to 6 hours While not in use (Standby) Up to 14 days While using the Clarity Booster feature Up to 4 hours
• Clean the charge contacts of the cordless handset and the charger with a soft, dry
cloth once a month. Clean more often if the unit is subject to grease, dust or high
humidity. Otherwise the battery may not charge properly.
Belt Clip
You can hang the cordless handset on your belt or pocket using the included belt clip.
To attach the belt clip To remove the belt clip
While pressing the top of the clip (1),
pull the right edge in the direction of the
arrow (
– 2 –
2).
1
2
Registration
O KO K
This cordless handset must be registered to the KX-TG2970 base unit. The cordless
handset will be assigned the extension number at registration. Only one cordless handset
can be registered at a time. Charge the battery fully. Make sure the base unit and the
other cordless handsets are not being used.
base unit nearby during registration.
Have both the
[-]
Press MUTE on
base unit, then
OK on handset to
register handset
cordless
handset and
To operate “ ”,
[MUTE] and Indicator
The cordless handset display shows the instructions as shown
on the right.
press the right soft key.
OK
Press MUTE on
base unit, then
OK on handset to
register handset
BACK
PLAY OK
1 Base unit: Press [MUTE].
• The MUTE indicator flashes. After the MUTE indicator starts flashing, the rest of the
procedure must be completed within 1 minute.
2 Cordless Handset:
(1) Press the soft key ( ).
OK
IN USE
SPI
PRIVACY
Handset
Registering
(2) Wait until 3 beeps sound and the display shows
the new extension number.
• Registration is complete.
Ex. Extension number 2
IN USE
SPI
PRIVACY
Handset [2]
Registered
1
1
-
]
2
]
• The registered number “[1]” to “[3]” is shown on the top right of the display.
• You can stop registration by pressing [OFF] on the cordless handset and pressing
[MUTE] on the base unit.
To cancel the handset registration, please see your base unit Operating Instructions.
For assistance, please call: 1-800-ADT-ASAP
– 3 –
Optional Headset
k
Connecting an optional headset to the cordless handset allows hands-free phone
conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88,
KX-TCA88HA, KX-TCA91, KX-TCA92 or KX-TCA98 headset. To order, call the
accessories telephone number on page 1.
Connecting an optional headset
Open the headset jack cover, and insert the headset plug into the headset jack as shown
below.
Headset Jack
Headset Jac
• Headset sold separately. Model shown here is KX-TCA88.
Wall Mounting
The charger can be wall mounted. Connect the AC adaptor. Install screws using the wall
template (see below). Mount the charger (A). Slide it down (B), then slide down to the
right (C) until it is secured.
2.45 cm
31
⁄32")
(
2.45 cm
(31⁄32")
Screws
(not included)
To Power
Outlet
Wall Template
A
B
C
– 4 –
Loading...