Panasonic KX-TGA270S User Manual

– 1 –
For assistance, please call: 1-800-211-PANA(7262)
PQQX13366YA-BM S0402-2062
Installing the battery
Insert the battery into the handset as shown, matching the correct polarity (#). Press the battery down until it places into the compartment ($). Close the cover.
Installation!
1
2
Power Outlet (AC 120 V, 60 Hz)
AC Adaptor
CHARGEGE
USE ONLY WITH Panasonic AC ADAPTOR KX-TCA1 (Order No. KX-TCA1-G).
The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel
warm during use.)
Installation Manual
PLEASE READ BEFORE USE AND SAVE.
KX-TGA270S is the optional cordless handset for the KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740. This installation manual only describes the steps necessary to start up the handset. Please read the KX-TG2700/KX-TG2720/KX-TG2730/KX-TG2740 operating instructions for further details.
2.4GHz Expandable Cordless Handset
Model No. KX-TGA270S
Charger Unit ...................................one
Charger Order No. PQLV30013ZS AC Adaptor
Order No.
KX-TCA1-G (KX-TCA1)
Handset Cover................................one
Order No. PQKK10126Z1
Battery..............................one
Order No. PQPP511SVC (P-P511)
Belt Clip............................one
Order No. PQKE10340Z1
Accessories (included) For extra orders, call 1-800-332-5368.
– 2 –
Clean the charge contacts of the handset and the charger with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or high humidity. Otherwise the battery may not charge properly.
Handset battery information
After your Panasonic battery is fully charged:
CHARGE Indicator
Charge Contacts
Charging the battery
Place the handset on the charger and charge for about 15 hours before initial use.
The CHARGE indicator lights, a beep sounds and
Charging will be displayed.
Recharge the battery when: –
Recharge battery” is displayed,
– “” flashes on the display, or the handset beeps intermittently while it is in use.
If the battery has been discharged, the handset will display Charge for 15HRS and “” when you place the handset on the charger. The handset will not work. Keep charging.
Operation Operating time
While in use (TALK)
While not in use (Standby)
While using the Reception Booster feature
Up to 4.5 hours
Up to 11 days
Up to 3.5 hours
(MUTE) Button and Indicator
O KO K
[-] Press MUTE on base unit, then OK on handset to register handset
A
B
Wall Mounting!
The charger can be wall mounted. Connect the AC adaptor. Install screws using the wall template below. Mount the charger (#). Slide it down ($) then slide down to the right (%) until it is secured.
$
#
%
Wall Template
2.45 cm (
15
16
")
Screws
To Power Outlet
2.45 cm (
15
16
")
– 3 –
The handset display shows the instructions as shown on the right.
1
Base unit: Press (MUTE).
The MUTE indicator light flashes.
2
Handset:
#Press the right soft key ( ). $Wait until a long beep sounds and the display
shows the registered number. The registration will be then complete.
The registered number [1]”to [8]is shown on the top right of the display.
You can stop registration by pressing (OFF) on the handset and pressing (MUTE) on the
base unit.
OK
SP
PRIVACY
[-]
Press MUTE on base unit, then OK on handset to register handset
OK
Ex. Extension number 2
SP
PRIVACY
[-]
Handset
Registering
SP
PRIVACY
[2]
Handset [2]
Registered
Registration!
This cordless handset must be registered at the KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740 base unit. The handset will be assigned the extension number at registration. Only one handset can be registered at a time.
Make sure the base unit and the other handsets are not being used. Registration must be completed within 1 minute.
(MUTE) Button and Indicator
O KO K
[-] Press MUTE on base unit, then OK on handset to register handset
Soft key ( )
OK
The illustration of the base unit is the KX-TG2730.
To cancel the handset registration, please see the KX-TG2700/KX-TG2720/ KX-TG2730/KX-TG2740 Operating Instructions.
A
B
For assistance, please call: 1-800-211-PANA(7262)
Loading...
+ 7 hidden pages