Panasonic ETWML100U User Manual

Operating Instructions

Mode d’emploi

Manuel d’utilisation

Wireless Module

Module sans fil

Módulo inalámbrico

Model No.

ENGLISH

FRANÇAIS

ESPAÑOL

TI0515HZ0 -ST
Printed in China

N° De Modèle.
Núm. de modelo

y

Before operating this product, please read the instructions carefully, and save
this manual for future use.

y

Avant d’utiliser l’appareil, lire attentivement ce mode d’emploi, et le conserver a

des ns de reference ulterieure.

y

Antes de utilizar este producto, lea cuidadosamente las instrucciones y guarde
este manual por si tiene que utilizarlo en el futuro.

ET-WML100U

TQBJ0868

ENGLISH

Precautions for safety

WARNING

■

Do not use this product near anyone with an implanted cardiac pacemaker.

Radio waves may interfere with the operation of the pacemaker.

■

Do not use this product in an aircraft.

Safety of navigation may be compromised.

■

Do not use this product near an automatic door, re alarm, or other automatic

control products.

Radio waves from this product may interfere with automatic control systems and cause
malfunctions resulting in accidents.

■

Do not use this product in hospitals or areas with the medical electronic equipment.

Radio waves from this product may interfere with the medical electronic equipment and
cause malfunctions resulting in accidents.

■

Do not pour liquid on this product or allow it to get wet.

Doing so may cause a re, electric shock or malfunction.

■

Keep the cap out of the reach of small children.

The accidental swallowing of the cap may have an adverse effect on the body.

- Consult a doctor in the event that ingestion of the cap is suspected.

CAUTION

■

Do not use this product in environments with excessive water, humidity, steam,
dust, oil smoke etc.

Doing so may cause a re or electric shock.

■

Do not place a clip or other metal object on the product.

Doing so may cause a re, electric shock or malfunction.

■

Do not disassemble or modify this product.

Doing so may cause electric shock.

Before Using the Product

Security

• Before using this product, please be aware of the following cases where damage may

occur.

- Leakage of your private information via this product

- Illegal operation of the projector via this product by a malicious third-party

- Harm to or cessation of operation of the projector via this product by a malicious third­party

• Refer to the projector operating instructions regarding security measures.

Cautions during use

• Attach the protective cap when not using or when carrying this product, and do not directly

touch the connector part.

• Do not place this product in an extremely hot location or where it will be subject to direct

sunlight.

• Do not drop this product or subject it to an impact or excessive force.

• Do not use this product with anything other than the projector which is compatible with this

product.

• Loading this product into computers and the like may cause faults or malfunctions.

• This product can only be used in the country or region of purchase.

• The following acts are prohibited by the radio law:

- modication or disassembly

- removal of the product label attached to the rear surface

R

Possible with this product

• Wireless LAN function can be easily added by inserting this product into the projector which

is compatible with this product.

• For more information about the projector which is compatible with this product, please visit

the following web site.
http://panasonic.net/avc/projector/products/optional_accessories/

About disposal

• When disposing of the product, ask your local authority or dealer about the correct methods

of disposal.

• Please dispose of the packaging appropriately after unpacking this product.

Method of Use

Attach this product to the wireless module connection terminal of a projector.
For details of how to attach this product to the projector, refer to the projector operating
instructions.

Part names

Cap

LED

LED

LED staus Status
Lighting (blue) The power is supplied.
Blinking (blue) When sending or receiving the data.

When this product is not correctly recognized

• Check that this product is rmly inserted as far as possible.

• Re-insert the product.

Consult your dealer if this product is still not recognized after carrying out the above actions.

Specications

External dimensions
(including cap)

Weight
(including cap)

Interface USB 2.0
Standards IEEE802.11b/g/n Compliant
Transmission Formats OFDM
Frequency Range

(Channel)
Data Transfer Speed

(standard value *1)

Access Format

Security

*1 This is a theoretical speed, and the actual transfer speed may vary depending on factors

such as the usage environment and connection products.

*2 IEEE802.11n is not supported.

Caution

• Unauthorized reproduction of the whole or part of these operating instructions is prohibited.

• The content of these operating instructions is subject to change without prior notication in

the future.

• Please understand that Panasonic cannot accept any responsibility regarding claims for

damage or lost earnings with use of this product given as the reason.

20 mm (W) x 8 mm (H) x 60 mm (L)

Approx. 13

]

2 412 MHz - 2 462 MHz (channels 1 - 11)

IEEE802.11n Max. 150 Mbps
IEEE802.11g Max. 54 Mbps
IEEE802.11b Max. 11 Mbps

Infrastructure Mode
Ad Hoc Mode *

2

WPA2-PSK (TKIP/AES)
WPA-PSK (TKIP/AES)
WEP (64 bit/128 bit)

For Users in Canada

Applicant name: Arcadyan
Manufacturer’s name: Arcadyan
Trade Name: Panasonic
Model Number: ET-WML100U

This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
For product available in the USA/Canada market, only channel 1~11 can be oper­ated. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction
with any other antenna or transmitter.
IMPORTANT NOTE : IC Radiation Exposure Statement
This equipment meets the SAR for general population/uncontrolled exposure limits of
IC RSS-102 and had been tested in accordance with the measurement methods and

procedures specied in IEEE 1528. This equipment should be installed and operated

with minimum distance 20 cm between the radiator & your body.

Declaration of Conformity

For Users in U.S.A.

Important Safety Notice

WARNING:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer­ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION:

and/or peripheral devices any changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate this

equipment.

FCC RF Exposure Warning:

- This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment.

- This equipment has been approved for mobile operation and requires minimum 20 cm spacing be provided between antenna(s) and all person’s body (excluding
extremities of hands, wrist and feet) during wireless modes of operation.

- This equipment may not be used with other installed transmitters, which may be capable of simultaneous transmission.

MISE EN GARDE:

Cet appareil a été testé et jugé conforme aux limites des appareils numériques de la classe B, conformément à l’article 15 du Règlement du FCC. Ces limites sont
destinées à assurer une protection raisonnable contre les interférences nuisibles dans une installation résidentielle. Cet équipement produit, utilise et peut émettre
de l’énergie de fréquence radio, et, s’il n’est pas installé et utilisé conformément aux instructions, il peut émettre des interférences nuisibles aux communications ra­dio. Toutefois, il nous est impossible de garantir que des interférences ne se produiront pas dans une installation particulière. Si cet appareil cause des interférences
nuisibles à la réception radio et télévisée, ce qui peut être déterminé en éteignant et en rallumant l’appareil, nous conseillons à l’utilisateur d’essayer de corriger les
interférences à l’aide de l’une des mesures suivantes :

• Modier l’orientation ou l’emplacement de l’antenne de réception.

• Éloigner le projecteur du récepteur.

• Branchez l’équipement à une prise appartenant à un circuit différent de celui auquel le récepteur est branché.

• Consulter votre revendeur ou un technicien expérimenté en radio et télévision.

PRÉCAUTION DE LA FCC:

la connexion à l’ordinateur et/ou à des périphériques. Les changements ou modications non expressément approuvés par la partie responsable de la conformité

pourraient annuler le droit de l’utilisateur à utiliser cet appareil.

Avertissement d’exposition RF de la FCC:

• Cet appareil satisfait aux limites d’exposition aux radiations de la FCC dénies pour un environnement non contrôlé.

• Cet appareil a été approuvé pour une utilisation mobile et nécessite un espacement de 20 cm au minimum entre l’antenne (les antennes) et le corps de toute per-

sonne (sauf des extrémités des mains, des poignets et des pieds) lors des modes de fonctionnement sans l.

• Cet appareil ne peut pas être utilisé avec d’autres émetteurs installés, ce qui peut provoquer la transmission simultanée.

ADVERTENCIA:

Este equipo se ha sometido a pruebas y se ha determinado que cumple con los límites de los dispositivos digitales Clase B según la Parte 15 de las normas de
la FCC. Estos límites están diseñados para proporcionar una protección razonable frente a interferencias perjudiciales en una instalación residencial. Este equipo
genera, utiliza y puede radiar energía de radiofrecuencia y, si no se instala y se utiliza conforme a las instrucciones, puede provocar interferencias perjudiciales en

las comunicaciones por radio. No obstante, no hay ninguna garantía de que no se produzcan interferencias en una instalación especíca. Si este equipo provoca

interferencias perjudiciales para la recepción de radio o televisión, lo cual se puede determinar apagando y encendiendo el equipo, animamos al usuario a tratar de
corregir la interferencia mediante una o más de las medidas siguientes:

• Reorientar o reubicar la antena receptora.

• Separar el equipo y el receptor.

• Conectar el equipo en una toma de corriente que pertenezca a un circuito distinto del que se conecta al receptor.

• Consulte con su distribuidor o un técnico experimentado sobre TV

PRECAUCIONES RELATIVAS A LAS NORMAS DE LA FCC:

adjuntas y utilice solo cables de interfaz apantallados para conectar con un ordenador o con dispositivos periféricos. Cualquier cambio o modicación no aprobada

expresamente por la parte responsable del cumplimiento podría anular la autoridad del usuario para utilizar este equipo.

Advertencias sobre exposición a RF según FCC:

• Este equipo se ha aprobado para el funcionamiento móvil y requiere una distancia mínima de 20 cm entre la antena y cualquier parte del cuerpo de cualquier

persona (lo cual excluye las extremidades de las manos, muñecas y pies) durante el modo de funcionamiento inalámbrico.

• Este equipo no se puede usar con otros transmisores instalados que pueden ser capaces de transmisión simultánea.

To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to computer

(if provided with wireless device)

Pour assurer une conformité continue, suivez les instructions de ce manuel et utilisez uniquement des câbles d’interface blindés lors de

(si un dispositif sans l est fourni)

Con el n de garantizar el cumplimiento continuo con las normas, siga las instrucciones de instalación

(si se suministra con el dispositivo)

Model Number: ET-WML100U

Declaration of Conformity

Trade Name: Panasonic
Responsible party: Panasonic Corporation of North America
Address: Two Riverfront Plaza, Newark, NJ 07102-5490
General Contact: http://www.panasonic.com/support
Projector Contact: http://www.panasonic.net/avc/projector

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DÉCLARATION DE LA FCC

1. Cet appareil est conforme à l’article 15 des règlements de la FCC. Son fonctionnement est soumis aux deux conditions suivantes :

(1) Cet appareil ne peut pas causer des interférences nuisibles.
(2) Cet appareil doit accepter toute interférence reçue, y compris les interférences qui peuvent causer un mauvais fonctionnement.

2. Les changements ou modications non expressément approuvés par la partie responsable de la conformité pourraient annuler le droit de l’utilisateur à utiliser cet

appareil.

DECLARACIÓN DE LA FCC

1. El uso de este dispositivo está sujeto a las dos condiciones siguientes:

(1) Este dispositivo no puede causar interferencias perjudiciales.
(2) Este dispositivo debe aceptar todas las interferencias recibidas, incluidas las que puedan causar un funcionamiento indeseado.

2. Los cambios o las modicaciones no aprobadas expresamente por la parte responsable del cumplimiento, podrían anular la autoridad del usuario para hacer

funcionar el aparato.