13
About Charging
• The battery is warmed during and after
charging, and after use. The camera is
also warmed during the operation,
however, it is not malfunction.
• Use the supplied cradle or AC adaptor
for this unit.
• Pull the plug out of the electrical outlet
after completing the charge.
• Do not disassemble or alter the cradle
or AC adaptor.
■ Battery indicator
The remaining battery power is displayed
on the LCD monitor in use.
The indication is changed as follows
→→(blinking)
according to the consumption of the
battery.
When the indicator is shown as
(blinking), the battery will be
exausted in a few minutes. Charge the
battery.
■ Charging time and available
recording time
(Recording condition)
• Temperature 85°F (25°C)/Humidity
60%
• Using the supplied battery and the SD
Memory Card
The times shown above may vary
depending on the condition.
■ Charging environment and
charging error
• Charge the battery in a place with the
temperature 50 - 95°F (10 - 35°C).
(The battery should also be the same
temperature)
• The Power/Card Access Lamp blinks
while charging. (Blinks approx. every 2
seconds when charging is normal.)
When the Power/Card Access Lamp
blinks more quickly or slowly (or turns
off), some abnormality may have
occurred. The flashing speed suggests
the following states.
Blinking approx. every 0.5 seconds:
• The SD Multi Camera, battery or AC
adaptor may be defective. Contact
your nearest Panasonic dealer.
Blinking approx. every 6 seconds:
• The ambient temperature or that of
the battery itself is too high or too
low. Charging proceeds, but will take
a longer time.
Turning off:
Charging is completed.
• If the Power/Card Access Lamp
turns off when charging is not
completed, the AC Adaptor or the
battery is probably defective.
Contact your nearest Panasonic
dealer.
• For details, refer to P69.
Charging time Approx. XX min.
Continuous
recording time
(recordable
number)
Approx. XXX min.
(equal to XXX still
pictures)
Playback time Approx. XXX min.
SV-AS10_PP.book 13 ページ 2003年7月11日 金曜日 午後8時57分