PANASONIC DMC-LX2, DMC-LS2, DMC-FX50, DMC-FZ50, DMC-TZ2 IMPORTANT SAFETY NOTICE
...
About Indication of the schematic diagram
IMPORTANT SAFETY NOTICE:
COMPONENTS IDENTIFIED WITH THE MARK
HAVE THE SPECIAL CHARACTERISTICS FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE.
1.Although reference number of the parts is indicated on the P.C.B. drawing and/or schematic diagrams, it is NOT mounted on the P.C.B. when it is displayed with "$" mark.
2.It is only the "Test Round" and no terminal (Pin) is available on the P.C.B. when the TP (Test Point) indicated as " " mark.
3.The voltage being indicated on the schematic diagram is measured in "Standard-Playback" mode when there is no specify mode is mentioned.
4.Although the voltage and waveform available on here is measured with standard frame, it may be differ from actual measurement due to modification of circuit and so on.
5.The voltage being indicated here may be include observational-error (deviation) due to internal-resistance and/or reactance of equipment. Therefore, handle the value indicated on here as reference.
6.Use the parts number indicated on the Replacement Parts List .
7.Indication on Schematic diagrams:
Circuit name being connected.
OFTR FEP
Name of Signal
This signal is connected
to the FEP schematic diagram.
8.Try to click on the subject repeatedly when the drawing screen link does not working properly.
Since data volume for double sides P.C.B. is heavy, it might be taking time for display and/or access.
Loading...