8
Lock the chassis to the cabinet by using
back the chassis locking brackets
8
Depending upon the location of the AC
outlet, route the AC cord to either left or
right side while installing the front grille.
Ä
Insert the air filter
Ä
C
L
O
S
E
V
E
N
T
O
P
E
N
Clockwise
9
Reattach the front grille to the cabinet
and secure it with screws
9
Å
Reattach the front intake grille
Å
Lift up
about 90°.
C
L
O
S
E
V
E
N
T
O
P
E
90°
Slide the front intake grille slightly to the right to reattach
the tabs and then push down to close tight.
NOTE: A “click” sound can be heard when the front intake grille
is pushed down.
N
Remove the air filter procedures
1
Push and release the bottom of the
front intake grille.
2
Lift up the front intake grille at 45°
until it is supported by the stopper.
3
Tilt up and pull out the air filter
by the holder.
1
2
45°
3
Electrical work
• Always use at the rated voltage and with a specific air
conditioning circuit.
• Some installation locations may require installation of a
shortcircuit breaker.
• A 16 Ampere time delay fuse or circuit breaker is required.
• Nominal cross sectional area of power supply wire must be
3 core x 1.5 mm
• The power supply must be from an independent circuit.
• All electrical installation must be made in accordance with local
wiring and safety regulations wherever applicable.
• There must be a double pole switch with minimum 3mm contact
gap in the fixed installation circuit. (Applicable for models without
power supply plug only.)
• Please consult your dealer concerning installation requirements.
2
or above.
“ ”
Stopper
C
L
O
S
E
V
E
N
T
O
P
E
N
•
•
• 16
• 3 x 1.5
•
•
•
3 (
)
•
CW-PC70/90YA(09-13) 1/30/01, 10:53 AM11
11