Ozito ORBITAL SANDER, HSS-5000U, HSS-5000 Instruction Manual

ORBITAL
SANDER

1/2 SHEET

INSTRUCTION MANUAL

SPECIFICATIONS

Input: 230-240V ~ 50Hz
Power: 350W
No Load Speed: 12,000 /min
Pad Shape: 1/2 Sheet
Pad Size: 230 x 115mm
Weight: 2.05kg

HSS-5000

WHAT’S IN THE BOX

Orbital Sander

ozito.com.au

Sanding Sheet x 3

ONLINE MANUAL

Scan this QR Code with your
mobile device to take you to
the online manual.

1 Front Handle

2 Metal Base Plate

3 Spring Clamp

4 On/Off Switch

5 Rear Handle

6 Dust Canister

ORBITAL SANDER

KNOW YOUR PRODUCT

1. ATTACHING SANDPAPER

SETUP & PREPARATION

Ensure the tool is disconnected from the power supply
before performing any of the following operations.

2. Fold the sandpaper to match the contours of the sanding pad.

1. Unlock the spring clamp on both sides of the sander.

4. Feed the paper under
the paper clip at the rear
of the sander. Lock the
clamp.

3. Feed the paper under
the paper clip at the
front of the sander. Lock
the clamp.

Note: Ensure the sanding sheet is rmly clamped and held at

against the base of the sanding pad.

7 Sandpaper x 3 (60 / 80/ 120 Grit)

ACCESSORIES

2. DUST CANISTER 3. CONTROLS

OPERATION

1/3 Full

2. To remove, pull
the dust canister
away from the dust
extraction port.

1. Push the dust
canister onto the
dust extraction port
until it clicks into
place.

Install

3. Regularly check the dust canister and empty when it becomes

1

/3 full for optimum dust extraction.

Remove

Empty

The tool is recommended for use with a residual current
device with a rated residual current of 30mA or less.

2. To turn the sander off, slide the switch back.

2. To turn the sander on, slide the switch forward.

1. Connect the tool to the mains power supply.

CAUTION: GUIDE THE CORD DURING SANDING TO

PREVENT IT BEING CAUGHT ON THE WORKPIECE,
OR OTHER OBJECTS.