Ozito HDR-5000 Instruction Manual

HAMMER
DRILL

1200W

INSTRUCTION MANUAL

SPECIFICATIONS

Motor: 1200W
Input: 230-240V ~ 50Hz
Chuck Size: 13mm (1/2”) Keyed
No Load Speed: 0-1,000 / 0-3,000/min
Impact Rate: 0-16,000/0-48,000bpm
Drilling Capacities: Timber 40mm
Steel 13mm
Masonry 16mm

HDR-5000

WHAT’S IN THE BOX

Hammer Drill

ozito.com.au

Depth Rod

Side Handle

Chuck Key

ONLINE MANUAL

Scan this QR Code with your
mobile device to take you to
the online manual.

KNOW YOUR PRODUCT SETUP & PREPARATION

1. SIDE HANDLE & DEPTH ROD

The side handle provides additional comfort, control, and guidance
for the hammer drill.

1. Loosen the side handle.
Slide handle onto the collar
mount of the hammer drill.

3. To adjust, loosen the
side handle.

1 Depth Rod

2 Chuck

3 Side Handle

4 Gear Selector

5 Hammer Selector

6 Speed Selection Dial

7 Variable Speed Switch

8 Forward/Reverse Lever

9 Lock-On Button

HAMMER DRILL

2. Adjust to any position, 360°
around the collar mount.
Tighten side handle.

4. Adjust the depth
rod so the bit
extends beyond
the end of the rod
to the required
drilling depth.

5. Tighten depth rod by
tightening side handle.

required

drilling depth

Depth Rod

Side Handle

The depth rod helps to drill to a pre-determined depth.

CAUTION: Ensure the tool is disconnected from the power
supply before performing any of the following operations.

10 Chuck Key

ACCESSORIES

2. CHUCK 3. ON/OFF SWITCH

2. To start drilling squeeze
the variable speed
switch.

3. To stop drilling release
the switch.

1. Open the chuck jaws
slightly larger than the
bit you wish to insert.

4. To ensure the bit is
securely fastend,
insert the chuck
key into 1 of the
3 holes on the
chuck. Turn chuck
key clockwise.

3. Hand tighten the chuck
jaws.

2. Insert the drill bit,
making sure it is
centred in the jaws.

OPERATION

4. To lock the drill on,
squeeze the variable
speed switch (a) then
depress the lock on
button (b).

5. Release the variable
speed switch, then the
lock on button.

6. To unlock the drill,
squeeze and release
the variable speed
switch.

Variable Speed Switch

Lock On Button

Keyed Chuck

a

b

a

b

WARNING! To reduce the risk of electric shock, the use
of a residual current device (rated 30mA or less) is
recommended.

1. Plug the tool into the mains power supply.

5. Repeat this step with the two remaining chuck holes.