Defender Roof Rack
Supplemental Note
Please Read this before Roof Rack installation
Although every Defender Rack is manufactured
from the highest quality materials, consideration
must also be given to the strength of the
mounting surface to which it is attached. If you
are going to drive under extremely rough
conditions, you must consider unloading the rack
to prevent it from tearing any thin sheet metal
surfaces.
Defender Roof Racks are rated for loads of no
more than 150 lbs. evenly distributed.
When carrying a spare tire, the tire should not
exceed 33” diameter.
Defender Series Rack Bracket
P/N DS20-4
1) Position Defender Rack evenly side to side and front to rear on factory rack.
2) Attach rack struts to rack mount with 1/4” x 21/4” u-bolts, flat washers, lock washers, and hex nuts
(see photo 1).
photo 1
WARRANTY POLICY
ORU (Off Road Unlimited), extends a lifetime warranty on their products to the original purchaser. The warranty covers defects in material and
workmanship. This warranty does not apply to wear items such as brakes, steering components, u-joints, etc., or to products sold by, but not
manufactured by ORU. Application of this warranty is subject to inspection of the product by ORU and at their sole discretion. ORU is not
responsible for shipping charges incurred to submit product for inspection, or its return if the warranty is declined. This warranty does not cover
parts that have been modified, applied outside of the intended application, or subjected to abuse. This warranty applies solely to the ORU product
and does not extend to any incidental damage(s) or incurred cost(s). No other warranties/guarantees are expressed or implied. All warranty claims
must be accompanied by the original receipt, or reasonable facsimile. To apply for warranty consideration, contact the ORU customer service
department at 818-563-1208.
offroadunlimited.com
page 2
Loading...