Oregon MP210 OPERATION GUIDE

FIRMWARE UPGRADE (Release v0.1)

NOTE: Please read this latest operation steps before execute the Firmware
upgrade.

If your MP3 player's display shows "Reformat as FAT16" when you power on the unit, or
you cannot access your removable disk when the device is connected to your PC, you
can also follow the instructions below to execute the firmware upgrade.

1. Go to the Oregon Scientific website (www.oregonscientific.com). Click the country
site that you purchased the player from and download the latest MP210 firmware
update (.zip file).

NOTE: If this is not the first time you are performing a firmware upgrade, please
uninstall the old version before installing the new firmware update.

2. Unzip the file and install the firmware update by double-clicking "setup.exe".

3. After the firmware update has been installed, restart your computer.

4. Click Start>Settings>Control Panel>System>Hardware.

5. In Hardware windows, click to open Device Manager.

6. Make sure you turn off the player. Press and continuously hold the PLAY
button while performing steps i) to iii):

i) Connect your player to the PC via the USB cable.
ii) Make sure to wait until “PLAYER RECOVERY DEVICE CLASS” shown.

on the device manager.

iii) Run the software by going to Start>Programs>Oregon Scientific

MP210>Firmware Upgrade. You will see a progress bar running.

7. Release the PLAY button until the current and updated firmware version is displayed
in a window.

8. Tick the Format Data Area box and then click the Start button.
NOTE: All data stored in the player will be erased.

9. Click the Start button to begin the firmware upgrade process.

10. Click the Close button to close the window once the process is completed.

11. Unplug the player from the computer.

12. Press the player's RESET button using a blunt narrow-tip stylus or ballpoint pen.

13. Turn the power on to begin operation again.