ORANGE CR50BXT, Pix Crush 50BXT Owner's Manual
IMPORTANT
A
ARA
PL
ORANGE MUSIC ELECTRONIC CO., LTD.
Printed in PRC.
To prevent serious damage be sure that the rated AC line voltage shown on the amplifier's rear panel agrees with
the line voltage available from your AC inlet before connecting the AC power cord.
CAUTION!TO REDUCE THE RISK OF FIRE. REPLACE ONLY WITH SAME TYPE FUSE
ATTENTION!#UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE
WARNING!
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
DO NOT REMOVE CHASSIS(OR BACK), NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
THE UNIT SHOULD BE INSTALLED SO THAT ITS LOCATION OR POSITION DOES NOT INTERFERE WITH ITS PROPER
VENTILATION. FOR EXAMPLE, IT SHOULD NOT BE SITUATED ON A BED, SOFA, RUG OR SIMILAR SURFACE THAT MAY
BLOCK THE VENTILATION OPENINGS.
RZQHU*V PDQXDO
A
L
E
N
LE
E
HAN
D
ME
Y
P
W
A
I
!
O
OVCASS
S
A
C)O
S
VAA
S
S
O
AAA
O
S
O
W
S
E
L
N
E
M
H
D N
A
C
O
S
AVIS! RESQUE DE CHOC ELECTIQUE-NE PAS OUV RIR.
INTRODUCTION
Congratulations on your Orange Pix Crush series purchase. You have chosen to buy the coolest practice amp
in the world! We hope you have lots of fun using your Crush amp, but before you start playing please take a
moment to read this manual and familiarize your self with your amplifier and its controls.
USING YOUR AMPLIFIER
Turn amplifier master Volume to "0" before turning amplifier ON or OFF.
To prevent hum operate your amplifier and instruments as far away from fluorescent and neon lamps as possible,
as they generate extremely high levels of electronic noise.
WARRANTY
Please refer to the enclosed warranty information sheet for details of your amplifier warranty.
You can register your purchase online on our website www.orangeamps.com
50BXT
PANEL FUNCTIONS
SPECIFICATIONS
FRONT PANEL
REAR PANEL
FUNCTION DESCRIPTIONS
1- INPUT : Use this jack to connect your guitar to the amplifier by means of a shielded instrument cable.
2- GAIN : This controls pre-gain level.
6- VOLUME : Controls the overall volume of the amplifier.
3- HIGH : Provides high frequency equalization as required.
4- MID : Provides middle frequency equalization with cut and boost.
5- LOW : Provides low frequency equalization as required.
7- AUX IN : Use this 1/8" stereo mini jack to connect the output of a CD or,MP3 player,Laptop,etc.,to the amp.(The jacks are internally summed to a mono signal).
8- HEADPHONE : For use with most stereo headphones.
9- POWER INDICATOR : LED indicates whether the power switch is ON or OFF.
8
7
9
6
5
4
3
OUTPUT POWER SPEAKER INPUT
INPUT SENSITIVITY
NOISE
HEADPHONE
JACK LEVEL
POWER
CONSUMPTION
POWER
REQUIREMENT
DIMENSIONS
(W)X(H)X(D)
WEIGHT CABINET
COLOR & FINISH
50 Watts RMS
@ 1% THD, 4 ohm
500mV @ 50W
(Headphone Impe. 8 ohm)
100V,120V,230V-
240V, 50/60Hz
16.5x18x10 inch
420x460x270 mm
Sturdy
Particleboard
Orange
Leatherette
Normal 48mV F=1KHz,
Volumes Tone Controls at Max
-25dB(Vol Max/M.Vol Max)
-55dB(Vol Max/M.Vol Min)
-30dB(Vol Max/M.Vol Min/Rev.Max)
1X 12" Guitar and AUX
110VA
34 lbs.(15.5kg)
CAUTION: To avoid possible damage to your hearing, do not use headphones for extended periods of time at extremely loud levels.
2
1
11
10
10- TUNER LED : This LEDs the tuning guide LEDs.
11- TUNER SWITCH : This push switch turns the Tuner On/Off.
12- AC MAIN POWER SWITCH : This switch turns the AC Main Power ON or OFF.
13- AC INLET & FUSEHOLDER : Connect the supplied standard 3-pin 'IEC' plug here.
14
15
14- SPEAKER OUTPUT : Use this jack to connect the amplifier to an external speaker. The internal speaker is disconnected when this jack is used. The impedance of the external
15- LINE OUTPUT : Use this unbalanced jack to send a line level signal to another amplifier, the mixung board, or recording consol.
12
13
speaker must be 4 ohms or greater. Do not attempt to use headphones in the speaker output jack!.
Loading...