Opti Multi Pull Up Bar User guide

Page 1
Opti Fitness Upper Body Door Gym
Assembly & User Instruction – Please keep for future reference
Important – Please read this instruction manual fully before assembly or using
These instructions contain important information which will help you get the best from
your equipment and ensure safe and correct assembly, use and maintenance.
Page 2
1. Consult physician before any exercise.
2. Please make sure the bolts & Screw are tightened and in working condition before you use this product. Inspect the unit is installed securely, and use according the guide below.
3. Free area shall be not less than 0.6m greater than the training area in the directions from which the equipment is accessed. The free area must also include the area for emergency dismount. Where equipment is positioned adjacent to each other the value of the free area may be shared. Keep unsupervised children away from the equipment.
4. Examine the equipment termly, especially for the easy damaged or wear parts, such as bolts and nuts, Safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g. connection points. Replace the defective comments components immediately and keep the equipment out of use until repair; Special attention to components most susceptible to wear.
5. Use the machine only for its intended use as described in this manual. DO NOT use attachments not
Warning & Cautions
Warning
Page 3
Tool required for assembly of this equipment: one screw driver and one adjustable wrench. (Customer self prepared)
Total mass of the product: 1.95KGS This product is suitable for the door inner frame of 70cm-80cm, and depth of 11cm–16cm.
Assembly
1
Warning
Page 4
Attention!
Make sure concave side of the holes on two Slide cross bars (1) facing to the two
Page 5
Notice:
2
Page 6
D
Fig. 1: Position the Stop frame so that it rests on the top of the door frame/molding.
Door Frame Installation
3
Page 7
Exercise Guide
Page 8
Ex
2. Push-Ups 3. Dips
4. Sit-Ups
Place door gym on the floor with the two slide cross bar against the lower position of the door
Exercise Guide
4
Page 9
Page 10
Key no
Description
QTY
Key no
Description
QTY
1
Slide cross bar
2
8
Ø6mm Spring clip
2
2
Middle cross bar
1
9
20×40mm End Cap
2
3
Stop Rail
1
10
Ф25mm End Cap
4
4
Curved bar
2
11
Ф22×Ф32×250mm Foam roll
2
Explode Parts Diagram
3
5
Page 11
Exploded Part List
Product Guarantee
This product is guaranteed against manufacturing defects from a period of
6
Page 12
YEAR
Page 13
Loading...