Omnimount Stellar 1002697 Assembly Manual

8

OmniMount Systems, Inc.

8201 South 48th Street • Phoenix, AZ 85044-5355

www.omnimount.com

Thank you for purchasing an OmniMount product.

Specifications are subject to change without prior notice.

Every effort has been made to provide accurate and error-free assembly and installation. OmniMount
Systems disclaims liability for any difficulties arising from the interpretation of information contained
in these instructions. If OmniMount products are used for purposes other than their original intent,
OmniMount, its distributors and retailers shall not be h el d responsible or liable for injuries or property
damage, direct, indirect, or consequential, which may arise from the inability to use this product safely,
properly, and in the manner for which it has been designed and manufactu red. Warranty does not
apply to products which have been lost, damaged by misuse, abuse, or accident.

Step 10

Route your systems cables through Cable Ports and out through opening in rear
of Back Post.

P/N 1002697 Rev A 02/2005

Assembly Instructions

IMPORTANT: Consult your dealer if you have any questions regarding

the proper assembly of this product.

• Three shelf video table

• Adjustable center shelf

• Ideal for large LCD/DLP, Plasma TV’s

• Cable management

Stellar Video Table: G363

2

Components:

ID Description Qty.

A

Top Glass Shelf 1

B

Middle/Bottom Glass

Shelves

2

C

Main Frame 1

D

Back Post 1

E

Main Support Legs 4

H

Long Hex Head Screws 10

I

Hex Screws 18

J

Cross Bar Bracket 2

K

Center Support Bracket 2

L

Self Adhesive Pads 16

M

End Caps 4

N

Cable Port Covers 2

G

Center Cross Bar 1

F

Center Support Legs 2

O

Large Hex Wrench 1

P

Small Hex Wrench 1

7

Step 9

Refer to Fig. 9.
Carefully lift and slide Bottom Glass Shelf (B) into place on lower frame members.
Carefully lift and slide Middle Glass Shelf (B) into place on center frame members.

Lift Top Glass Shelf (A) into place on top frame members.

Note: If the top shelf glass is unstable, move the rubber pad positions or, using the
extra adhesive pad, double up the height of the lowest pad until the shelf glass is
stable.

Caution: Never try to move table by pulling on glass shelves. Always move table by
grasping the table frame assembly.

Fig. 9