Omega Products FTB691-CK Installation Manual

Computer Assembly Kit for FTB690 Series Meter

M-4776/0309

InstallatIon InstructIons

1. Your meter should be installed with the arrow pointed in the direction of ﬂow. You can rotate the computer electronics 180 degrees before you install the computer.

2. Check that the batteries are secure in the back of the

computer.

3. Mount the computer on the turbine with the four screws at the corners of the faceplate. Make sure the O-ring is fully seated before tightening the screws.

4. Check meter accuracy before using. Make sure there is no air in the system by starting the ﬂow until it runs steadily. Then stop the ﬂow using a valve or nozzle.

5. Hold down DISPLAY button for three seconds to zero the meter’s Batch Total. When zeroes appear, release the button.

6. Meter an exact known volume into an accurate container. For best results, meter with one continuous full stream.

7. Check the readout. If the amount metered is accurate, ﬁeld calibration is not necessary. If not, refer to the Calibration

Section in your Owner’s Manual.

This Kit includes:

• Replacement Computer Assembly with Two Lithium Batteries

• Four Screws

• One O-Ring

Use with Kits:

FTB691-CK

FTB692-CK

FTB693-CK

FTB694-CK

FTB695-CK