Oki Data 4465873A User Manual

4465873A set up manual

4465873A are attached printer base unit according to the following figure.
Function of 4465873A is next page.

Toner cartridges and image drum
units set area

4465873A

Printer base unit

FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna -Increase the separation between the
equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

FCC Requirement

FCC WARNI NG
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equip m ent.

NOITCE
This equipment has been tested found t o comply with t he limits for a Class B digita l dev ice, pursu ant t o part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interferenc e t o r adio or t elevision reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna –Increase the separation between the equipment and receiver. –
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult
the dealer or an experienced r adi o/ TV technician for help.

IC Requirement

This device complies with I ndustry Canad a licenc e-e xe mpt RSS stan dard( s). O perat ion is sub ject to t he following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired op er at ion of the device.