Ohlins HO424 Mounting Instructions

Shock Absorber for Honda MSX125

HO424

Mounting Instructions

Note!

Please note that this image is a general representation
of the product and may differ slightly from your product.

Note!

Please note that during storage and transportation,
especially at high ambient temperature, some of the oil
and grease used for assembling may leak and stain the
packaging. This is in no way detrimental to the product,
wipe off the excessive oil/grease with a cloth.

Note!

Before installing this product, check the contents of the
kit. If anything is missing, please contact an Öhlins dealer

.

Warning!

Before installing this product, read the Öhlins Owner’s
Manual. The shock absorber is an important part of your
vehicle and will affect the stability.

Kit Contents

Description Part No Pcs

HO424 1
01185-01 2
01185-04 2
00710-01 2

Shock absorber
Sticker Öhlins
Sticker Öhlins
C-spanner
Owners manual

07241-02 1

2

MOUNTING INSTRUCTIONS

1

Put the motorcycle on a center stand so that
the rear wheel barely touches the ground.
Make sure the motorcycle is in a stable
position.

2

Remove the fairing on left side. First remove
the screw. Then push the center rivet pin with a
small pin to release it.

3

Loosen the upper and the lower bolts of shock
absorber.

4

Mount the Öhlins shock absorber onto the
motorcycle.

5

Tighten the upper and the lower bolts according
to HONDA service manual.

6

Reload the rivet the side fairing.Push the
center pin back into original position.

7

Remount the left fairing.

Warning!

It is advisable to have an Öhlins dealer install the shock
absorber.

Warning!

If working on a raised vehicle, ensure it is securely
supported so that it will not tip over.

Note!

Before mounting this product clean the vehicle
thoroughly.

Note!

When working on this product, always see the Vehicle

Service Manual for vehicle specic procedures and

important data.

Note!

Lower the vehicle so that the suspension is slightly
compressed before tightening the screws.

Caution!

Ensure that all screws are tightened to the correct
torque and that nothing fouls or restricts movement
of the shock absorber when the suspension is fully
compressed or extended.

8

Retighten the screws on the side fairing
according to HONDA service manual.

9

Lock the rivet by pushing in the center pin.