
MHDMI to RS-232 Kit
Instructions
Overview
The MHDMI to RS-232 kit (ADP-MHDMI-RS232) contains the following cables:
JAZ-CBL-DB15 Accessory Cable
DB15M-to-DB9F Serial Port Cable
These cables allow an Ocean Optics device with an MHDMI connector (such as STS and Jaz) to
interface to an accessory device’s RS-232 connection. For more information on RS-232
communication with these devices, see the following documents on Ocean Optics’ Engineering
documents page (
STS Data Sheet
Jaz Data Sheet
http://www.oceanoptics.com/technical/engineeringdocs.asp):
030-40000-000-01-201109 1

MHDMI to RS-232 Kit Instructions
JAZ-CBL-DB15 Accessory Cable
The Ocean Optics JAZ-CBL-DB15 is an accessory cable for the MHDMI connector on the STS and
Jaz Spectrometers. This 12-inch cable connects the 19-pin mini-HDMI accessory connector on the
STS Spectrometer or the Jaz DPU GPIO (or the JAZ-ADP-GPIO Adapter) and terminates in a DB15
connector. For more information on the JAZ-ADP-GPIO Adapter, see the JAZ-ADP-GPIO Adapter
and JAZ-CBL-DB15 Accessory Cable Instructions
http://www.oceanoptics.com/technical/operatinginstructions.asp).
(
JAZ-CBL-DB15 Cable
Connecting the JAZ-CBL-DB15 Cable
on Ocean Optics’ Operating Instructions page
► Procedure
1. Connect the accessory cable to the 19-pin mini-HDMI connector on the Jaz DPU module or
the STS Spectrometer.
2. Connect the other end of the cable (with the DB-15F connector) to the DB15M-to-DB9F cable
or to the accessory being used.
2 030-40000-000-01-201109