SETTING THE TIME
Your Oakley timepiece features a screw-down crown for added protection against
moisture. After it is unscrewed from the case, the crown can be pulled out to two
click positions for setting the date and time. To set the date and time the
first
time
(or to reset the date and time after the battery is changed), do the following:
CRANKCASE THREE-HAND INSTRUCTIONS MANUAL 03
TO SET THE TIME
1. Pull the crown out to the first click position (a).
2. Turn the crown until yesterday’s date appears.
3. Pull the crown out to the second click
position (b).
4. Turn the hands forward until today’s date
appears, then continue forward until the
current time is reached. If the current time
is in the afternoon or evening, move the
hour hand all the way around the dial to
pass 12 o’clock noon.
5. Push the crown back in. Gently turn the
crown clockwise until it screws back into
the case.
To set the exact second, wait until the
second-counting hand reaches “60” before
you pull out the crown to the second click
position (b). Set the time then wait until
the exact second is reached before
pushing the crown back in.
Second Hand
Date
Crown
CRANKCASE™THREE-HAND
Engineered for a life with momentum, this Swiss Made timepiece lets you gauge
the moments that refuse to stand still. Impact forged stainless steel puts an edge
of distinction on the art of Oakley, and precision is honed with 5 jewel movement.
Carbon reinforced impact bumpers are matched with a pure sapphire crystal and
case shielding that can withstand water pressure equivalent to a depth of 330
feet (100 meters). This sport-inspired design combines rugged durability with
sophisticated ease for a life in motion.
02 CRANKCASE THREE-HAND INSTRUCTIONS MANUAL
ab
USING THE ROTATING BEZEL
The top bezel can be rotated to measure time intervals. Rotate the bezel
counterclockwise to align the “60” mark (which is also the zero mark) with the
minute hand on the main dial face. After a time interval, use the numbers on
the bezel to read the elapsed time in minutes. Note that the bezel rotates in
only one direction.
POWER SAVING MODE
When the timepiece is not in use, the battery life can be prolonged by pulling the
crown out to the second click position (b). This will stop the hands and reduce
power consumption.
LOW BATTERY INDICATOR
When the battery is running low, the small second hand will move in four-second
intervals. If this occurs, the watch will continue to display time accurately but the
battery should be replaced as soon as possible.
CRANKCASE THREE-HAND INSTRUCTIONS MANUAL 05
TO ADJUST THE TIME AND DATE FOR SUBSEQUENT SETTINGS, USE
THESE SHORT PROCEDURES
TO SET THE TIME
1. Pull the crown out to the second click position (b).
2. Turn the crown until you reach the correct time.
3. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case.
TO SET THE DATE
1. Pull the crown out to the first click position (a).
2. Turn the crown until you reach the correct date.
If the current time is between 9:30 PM and 3:00
AM, set the date to the following day. (This is
necessary to ensure the date display will
normally change at midnight instead of 12
noon.)
3. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case.
04 CRANKCASE THREE-HAND INSTRUCTIONS MANUAL
ab