NuTone GF1200N, GF900N User Manual

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

Gable Fan

MODEL: GF1200N, GF900N

IMPORTANT SAFETY INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

(A) Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer.

(B) Before servicing or cleaning unit, switch power off at service

panel and lock service panel to prevent power from being
switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to
the service panel.

CAUTION: For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

CAUTION: This unit has an unguarded impeller. Do not use in

locations readily accessible to people or animals.

INSTALLATION INSTRUCTIONS

WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

(A) Installation work and electrical wiring must be done by qualified

person(s) in accordance with all applicable codes and
standards, including fire-rated construction.

(B) Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to
prevent back drafting. Follow the heating equipment
manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code
authorities.

(C) When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.
(D) Ducted fans must always be vented to the outdoors.
(E) NEVER place a switch where it can be reached from a tub or

shower enclosure.

•

READ INSTRUCTIONS CAREFULLY BEFORE PROCEEDING.

• WARNING: To reduce the risk of fire or shock do not use with solid

state speed control.

• This fan is intended for installation behind existing attic louvers.

SPECIFICATIONS: Thermally protected motor operates on 115vAC,

60 cycle. Large 14" fan blade, 15 inch diameter shroud.

ASSEMBLING THE UNIT

Refer to Figure 1.

Using provided hardware attach the mounting brackets to the unit.

MOUNTING THE UNIT

Refer to Figure 2.

• Secure unit to structure inside the attic.

• 2" x 4" wall studs may be modified to allow for proper spacing.

• Cover remaining area of louver. (See Figure 3)

Important: For every 300 CFM of fan performance, a minimum of one

square foot of inlet space is necessary for proper operation. Air inlet
area should be located as far from fan location as possible.

FIGURE 1

FIGURE 2

FIGURE 3

MOUNTING
BRACKETS

MOUNTING THE THERMOSTAT

Refer to Figure 2.

Mount the thermostat to a nearby rafter using screws
(not provided) through the mounting tabs.

Product specifications subject to change without notice.
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in U.S.A., Rev. 4/2001, Part No. 87735

WIRING THE THERMOSTAT

Refer to Figure 4.

This fan is designed to run on 120vAC, 60 Hz power only.
CAUTION: be sure to shut off electricity before wiring

thermostat.

With electricity turned off at the circuit breaker box, wire
thermostat as shown in the diagram above. Electrical
connections and wiring should be done by a qualified
electrician in accordance with all local and national electrical
codes.

Set thermostat for desired turn on temperature.

MAINTENANCE

CAUTION: Before cleaning or servicing unit, make
sure power is disconnected at service panel. (See
important safety instructions on page 1)

At the beginning of each ventilating season, check fan for
any debris that may be blocking fan blades, screen, or
motor ventilation openings.

To extend motor life, lubricate motor at the beginning of
each ventilating season. Oil ports are located on the front
and back of the motor. Use 5 or 6 drops of 20W non­detergent motor oil in each port.

FIGURE 4

One Year Limited Warranty

WARRANTY OWNER: NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period
of one (1) year from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this one year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES, FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES
FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident,
improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.

NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS
WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH
PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may

not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

WARRANTY SERVICE: To qualify for warranty service, you must (a) notify NuTone at the address stated below or telephone [phone], (b) give the model
number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present
evidence of the original purchase date.

Date of Installation Builder or Installer

Model No. and Product Description

IF YOU NEED ASSISTANCE OR SERVICE:

For the location of your nearest NuTone Independent Authorized Service Center:

Residents of the contiguous United States Dial Free 1-800-543-8687

Please be prepared to provide:

Product model number • Date and Proof of purchase • The nature of the difficulty

Residents of Alaska or Hawaii should write to: NuTone Inc. Attn: Department of National Field Service, 4820 Red Bank Road, Cincinnati Ohio 45227-1599.
Residents of Canada should write to: Broan-NuTone Canada, 1140 Tristar Drive, Mississauga, Ontario, Canada L5T 1H9.

Rev. 03/2001

BLACK LEAD

FROM MOTOR

BLACK LEAD

HOUSE SUPPLY

SUPPLY

GROUND

FAN MOTOR

WIRING

WHITE LEADS
FROM MOTOR

AND HOUSE

SUPPLY

HOUSE SUPPLY

WIRING