Northern Industrial Tools AirRatchet Wrench User Manual

Air Tools

ITEM# 1951202

1/2" Air Ratchet Wrench

USER'S MANUAL

Read carefully and understand RULES FOR SAFE OPERATION and instructions

before operating. Failure to follow the safety rules and other basic safety

precautions may result in serious personal injury.

Made in China

For technical questions and replacement parts, please call 1-800-222-5381.
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., Product!
For future reference, please complete the owner's record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the
entire instruction sheet to become familiar with this product before you begin using it.
This product is designed for certain applications only. Northern Tool + Equipment
strongly recommends that this product is not modified and/or used for any
application other than that for which it was designed. If you have any questions relative
to a particular application, DO NOT use the product until you have first contacted
Northern Tool + Equipment to determine if it can or should be performed on the product.
Before using this product, please read the following instructions carefully.

Technical Specifications

Item

Square Drive

Free Speed

Max. Torque

Air Consumption

Description

1/2" 1/4"- 18NPT

145 RPM

65 ft-lbs

4.5 CFM

Item

Air Inlet Diameter

Min. Hose Size

Max. air pressure

Description

3/8"

90 PSI

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures, parts list and assembly diagram.
Keep this manual and invoice in a safe and dry place for future reference.

WARNINGS AND SAFETY RULES

1.Wear proper clothing. Always use ANSI-approved safety impact goggles when
assembling or using this tool. Wear long sleeved shirts, long pants and hard-toed shoes.
Take off any loose fitting jewelry and keep long hair covered to prevent being caught in
moving parts.

2.Keep work area clean and well lighted. A dim and/or cluttered work area invites
personal injury.

3.Keep children and pets away from work areas. Children can be a distraction and should
be supervised by an adult when near the work area. Never allow children to play with
this product even if it is turned off.

4.Store idle tools properly. Keep this tool out of the reach of children.

5.Do not use the wrench if under the influence of alcohol or prescription drugs, or if you
are tired. Doing so may cause damage to the tool, or personal injury. Do not use this or
any tool if you are tired. Use common sense at all times.

6.Always use the proper tools. This tool was designed for a specific task. Do not alter this
tool, or use it for a purpose for which it was not intended.

7.Be careful when connecting/disconnecting air supply. It is recommended to use quick
disconnects (not included) rather than screw-on air connections.

8.Use compressed air only. Clean, dry, regulated compressed air at 90 PSI. Never use
oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source
for this tool.

9.Always disconnect air supply when this tool is not being used.
NOTE: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under
stood by the operator that common sense and caution are factors that cannot be built
into this product but must be supplied by the operator.

1 of 4