Važno: Važne informacije o sigurnoj upotrebi uređaja i baterije pročitajte u odjeljcima „Radi
vaše sigurnosti“ i „Sigurnost proizvoda” u štampanom korisničkom vodiču ili na lokaciji
www.nokia.com/support prije nego što počnete koristiti uređaj. Prve korake za korištenje
novog uređaja možete pronaći u štampanom korisničkom vodiču.
To lock the keys, press and hold and select Lock . To unlock the keys, select Unlock .
Avoid touching the antenna area while the antenna is in use. Contact with antennas affects the
communication quality and may reduce battery life due to higher power level during operation.
Do not connect to products that create an output signal, as this may damage the device. Do
not connect any voltage source to the audio connector. If you connect an external device
or headset, other than those approved for use with this device, to the audio connector, pay
special attention to volume levels. Parts of the device are magnetic. Metallic materials may be
attracted to the device. Do not place credit cards or other magnetic storage media near the
device, because info stored on them may be erased.
Some of the accessories mentioned in this user guide, such as charger, headset, or data cable,
may be sold separately.
12. Camera
13. Loudspeaker
14. Back cover opening slot
15. USB connector
SET UP AND SWITCH ON YOUR PHONE
Learn how to insert the SIM card, memory card, and battery, and how to switch on your phone.
Nano-SIM
Important: This device is designed to be used with a nano-SIM card (see figure) only. Use of
incompatible SIM cards may damage the card or the device, and may corrupt data stored on
the card.
Use only compatible memory cards approved for use with this device. Incompatible cards may
damage the card and the device and corrupt data stored on the card.
Note: Switch the device off and disconnect the charger and any other device before removing
any covers. Avoid touching electronic components while changing any covers. Always store
and use the device with any covers attached.
Open the back cover
1. Put your fingernail in the small slot at the bottom of the phone, lift and remove the cover.
1. Slide the SIM card holder to the left and open it up.
2. Place the nano-SIM in the SIM slot face down.
3. Close down the holder, and slide it to the right to lock it in place.
Insert the second SIM card
1. Slide the SIM card holder of the SIM2 slot to the right and open it up.
2. Place the nano-SIM in the SIM2 slot face down.
3. Close down the holder, and slide it to the left to lock it in place. Both SIM cards are available
at the same time when the device is not being used, but while one SIM card is active, for
example, making a call, the other may be unavailable.
Savjet: Pogledajte oznaku na prodajnoj kutiji da biste saznali može li vaš telefon koristiti 2 SIM
kartice. Ako se na oznaci nalaze 2 IMEI koda, imate telefon s dvije SIM kartice.
Insert the memory card
1. Slide the memory card in the memory card slot.
2. Put back the battery.
3. Put back the cover.
Switch on your phone
Press and hold the power key until the phone vibrates.
Select which SIM card to use
1. Press the scroll key and select Settings > Network & Connectivity > SIM manager .
2. To choose which SIM to use for calls, select Outgoing Calls , and select SIM1 or SIM2 .
3. To choose which SIM to use for messages, select Outgoing messages , and select SIM1 or
SIM2 .
4. To choose which SIM to use for mobile data, select Data , and select SIM1 or SIM2 .
Tip: To be able to distinguish your SIM cards, give them a descriptive name. In the
SIM manager settings, select each SIM card, type in the name, and select Save .
Your battery has been partially charged at the factory, but you may need to recharge it before
you can use your phone.
Charge the battery
1. Plug the charger into a wall outlet.
2. Connect the charger to the phone. When done, unplug the charger from the phone, then
from the wall outlet.
If the battery is completely discharged, it may take several minutes before the charging
indicator is displayed.
Tip: You can use USB charging when a wall outlet is not available. Data can be transferred
while charging the device. The efficiency of USB charging power varies significantly, and it
may take a long time for charging to start and the device to start functioning. Make sure your
computer is switched on.
Save power
To save power:
1. Charge wisely: always charge the battery
fully.
2. Select only the sounds that you need:
mute unnecessary sounds, such as keypad
sounds.
3. Use a wired headset, rather than the
loudspeaker.
4. Change the phone screen settings: set the
phone screen to switch off after a short
time.
5. Lower the screen brightness.
6. When applicable, use network connections,
such as Bluetooth, selectively: switch the
connections on only when you are using
them.
7. Turn off Wi-Fi hotspot when internet
sharing is not needed.
Trouble hearing your phone ringing in noisy environments, or calls too loud? You can change
the volume to your liking.
To change the volume during a call, press the scroll key up or down.
To change the volume of your media apps, ringtones, alerts, and alarms, press the scroll key
and select Settings . Scroll right to Personalization , and select Sound > Volume .
To change the volume when listening to the radio or music, select Options > Volume .