2
www.ninjakitchen.com
SPECIAL SAFETY INSTRUCTIONS
• Adetachablemagneticpower
cord is provided to reduce the
risk resulting from becoming
entangled in or tripping over a
longer cord. An extension cord (or
longer detachable cord) is not
recommended for use with deep
fryers.
• Never plug the unit into an
electrical outlet before the oil
reservoir has been filled with oil.
• DO NOT immerse the deep fryer or
the break-away safety power cord in
water.
• CAUTION: Condensation from the
deep fryer lid may cause splattering
when being opened and closed.
• Whenopeningthelidafterfrying,
lift slowly and carefully away from
you to allow the steam inside to
escape before opening fully.
• Toavoidacircuitoverload,DO
NOT operate another high wattage
appliance on the same circuit.
WARNING: Extension cords
are not recommended for use with this
product.
SAVE THESE
INSTRUCTIONS
10. Extreme caution must be used
when moving any appliance
containing hot oil or other hot
liquids.
11. DO NOT leave appliance
unattended while in use.
12. DO NOT use outdoors.
13. DO NOT place on or near a hot gas
or electric burner, or in a heated
oven.
14. Place your deep fryer on a heat
resistant countertop or table close to
an electrical outlet.
15. DO NOT place anything on top of
the deep fryer.
16. Only use appliance for its intended
purpose.
17. DO NOT add food with ice crystals
or if it has water droplets to the hot
oil.
18. DO NOT let the power cord hang
over the edge of the table or
counter or let it touch hot surfaces.
19. When the unit is in use, ensure that
the fryer basket handle does not
extend over the counter surface
to help avoid accidental spills and
tipping of unit.
20. Before disconnecting the Ninja®
Professional Frying System from the
electrical outlet, press the Start/Stop
button to stop cooking. Wait at least
60 seconds before removing the
break-away safety power cord from
the outlet. Always hold the plug,
and never pull the cord.
21. Store the appliance indoors to
prevent electronic parts failure.
F300_15_F300C_15_IB_ENG_121114_3.indd 2 12-11-14 2:38 PM