Nikon HMSC7075 User Manual
Introduction
Congratulations on your purchase of the Motorola Wireless Keybpad Kit. This module enables you to arm or disarm
your entire Motorola homesight™ system at once upon entry or exit of your home. Its security design ensures that
only a registered Keypad Key can set the system.
Using Your Home/Away Module
Position the Keypad module at an entrance to the house, near the garage door, laundry room door, or front door.
1 Touch your Keypad Key to the Keypad port momentarily to make digital identification.
2 The Keypad emits one short beep to let you know the key was read.
3 The status LED turns red if the key was not accepted.
4 The status LED turns green to let you know the key was accepted.
5 Push either the Home or Away button, as is appropriate. The button will flash while the system responds.
6 When the system finishes responding, the Keypad will beep twice and the Home/Away Port will briefly remain
lighted before turning off and becoming disabled. The Keypad port will blink from there on to assist you in locating
it in the dark.
Feature Locator
How It Works
Data and
status LEDs
Keypad port
Back View
AWAY
DATA
STATUS
HOME
Away button
Home button
KEY
DISCOVERY
Discovery
button
The Wireless Keypad can communicate with the Wireless System Controller to a distance
of up to 60 feet indoors, and 200 feet outdoors. The controller then relays the Home or
Away setting to the Motorola homesight™ program, arming or disarming devices.
2
AWAY
DATA
STATUS
HOME
Controller
KEY
Package Contents
AWAY
DATA
STATUS
HOME
KEY
Keypad
Module
(2)
Keypad
Keys
Tabletop
Mounting
Base
Hardware
Mounting
Kit
2 AA
Batteries
12V Power
Adapter
Discovery
Tool
Installation Overview
To install your Keypad module:
1 Choose an appropriate location for the Keypad module as described in Installation Hints.
2 Install batteries or plug the AC adapter into the wall and the module.
3 Register the module with your Wireless System Controller using a process called discovery. Refer to your
Wireless System Controller documentation for instructions on how to discover your Wireless Keypad.
4 Touch your Keypad Key(s) to the Kepypad port and click on Settings/Key Management in the Motorola
homesight™ software to see that the key has been registered.
5 Mount the module, using either the tabletop base, or by following the instructions for wall mounting.
Back View
DISCOVERY
Discovery
Button
Installation Hints
The Motorola Wireless Keypad module is constructed of UV-resistant ABS plastic.
Please consider the following points when mounting the module:
• If installing the Wireless Keypad outside, it should be shielded from the elements, such as underneath a porch
roof. Do not install the module where it is subjected directly to the elements.
• Typically, the module's wireless reception is good up to 60–200 feet from the Wireless System Controller
depending on indoor or outdoor use and the number of obstacles. These can include metal framing, thick walls,
and other wireless devices operating at 418 MHz. It is recommended that different positions be tried for optimal
results.
• If battery operation is preferred, pry off the back cover by lifting the cover at the bottom area where the AC power
supply would be connected. Lift and slide the cover down to remove it, and install the batteries.
3
Loading...