Netgear NMVDSLB, NMVDSLA Quick Start Manual
Installation Guide
DSL module
ProSECURE® UTM VDSL/ADSL2+ Module
UTM VDSL/ADSL2+ Module, Annex A. Part number: NMVDSLA-10000S
UTM VDSL/ADSL2+ Module, Annex B. Part number: NMVDSLB-10000S
This guide describes how to install and remove the ProSECURE Unified Threat
Management (UTM) VDSL/ADSL2+ Module. The DSL module is intended for use in
a UTM9S or UTM25S firewall.
For information about how to configure the DSL module, see the UTM reference
manual, which you can access from the UTM web management interface or
download from the NETGEAR support site at
http://support.netgear.com.
Install the DSL Module
The UMT9S and UTM25S each provide two network module slots. You can install
the DSL module in either slot. You can install only one DSL module. The other slot is
available for an optional wireless network module (NMWLSN-10000S).
To install the DSL module:
1. Turn off power to the UTM.
2. On the UTM front panel, remove one of the blank plates that cover the slots.
Save the cover plate for possible later use.
3. Insert the DSL module firmly into the slot.
Make sure that you align the sides of the DSL module with the slot guides on
each side of the slot. The following figure shows correct insertion.
4. Secure the DSL module using the two panel screws.
5. Turn on power to the UTM.
WARNING: The slot guides are not on the bottom of the slot. Do not insert the DSL
module into the bottom of the slot (you might damage the DSL module). The following
figure shows incorrect insertion.
Remove the DSL Module
To remove the DSL module:
1. Turn off power to the UTM.
2. Remove the two screws that secure the DSL module.
3. Pull the DSL module straight back from the slot.
4. Do one of the following:
• If you replace the DSL module, follow steps 3 and 4 in Install the DSL
Module.
• If you do not replace the DSL module, install a cover plate over the slot.
5. Turn on power to the UTM.
Package Contents
• DSL module (Annex A or Annex B)
• Installation guide
Support
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your product and
use it to register your product at
You must register your product before you can use NETGEAR telephone support.
NETGEAR recommends registering your product through the NETGEAR website.
For product updates and web support, visit
NETGEAR recommends that you use only the official NETGEAR support resources.
You can get the user manual online at http://downloadcenter.netgear.com or through
a link in the UTM’s web management interface.
For the current EU Declaration of Conformity, visit
http://support.netgear.com/app/answers/detail/a_id/11621/.
https://my.netgear.com.
http://support.netgear.com.
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of
NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries. Information is subject to
change without notice. © NETGEAR, Inc. All rights reserved.
Intended for indoor use only in all EU member states, EFTA states, and Switzerland.
March 2013
NETGEAR, Inc.
350 East Plumeria Drive
San Jose, CA 95134 USA
Loading...