Nero 7411712, Mountie 1400 Instruction Manual

INSTRUCTION MANUAL

NERO Mountie 1400 Hair dryer

（Code: 7411712）

The Nero Wall-Mounted Hair Dryer combines safety, convenience and power-saving with a

modern, streamlined design. It can be installed either in a drawer or upon a wall.

Features:

1. Power switch to allow unit to be turned off when not in use.

2. Two heat settings.

3. Lightly press spring button to turn on, release switch to turn off.

Components:

1. Dryer body

2. Spring button

3. Swift switch

4. Front cover

5. Back cover

How to install this unit with plug-connected wire:

1. Drill 2 holes of 6mm diameter according to the dimensions shown in picture 2, then

insert toggle into the holes and fix hanger to top hole.

2. Fix front and back cover on wall with the screw, then insert toggle into screw hole.

3. Connect with general power and move power switch to “ON” position.

How to install this unit without plug-connected wire:

1. Follow first step of the method above.

2. Loosen the screws as in picture 3 and picture 4 to remove front cover and attach to

plug-connected wire from terminal.

3. Open the wire entry hole; pull the reserved wire through that hole.

4. Fix the reserved wire on terminal, note direction of N, L wire, replace terminal to its

original position.

5. Fix the front and back cover on wall with the screws.

6. Turn on general power and move power switch to “ON” position.

How to install in drawer:

1. Drill two holes of 4mm diameter. The distance between the two holes is 80mm.

2. Fix the base of this unit on bottom board of drawer with the screws as in picture 5.

3. Turn on general power and move power switch to “ON” position.