Nemox Sweet 4 Pozzetti User guide

EN

INSTRUCTION BOOK

it
fr
de
Es

ISTRUZIONI PER L’USO

MODE D’EMPLOI

BEDINUNGSANLAITUNG

ISTRUCCIONES PARA EL USO

www.nemox.com

9

5

1

8

4

3

2

7

6

2

U.K.: INSTRUCTIONS I: ISTRUZIONI D' USO FR: MODE D’EMPLOI

1) Master switch

2) Compressor on light

3) Lower temperature button

4) Raise temperature button

5) Covers

6) SET button

7) FN button

8) Water drain caps

9) Water drainage

DE: ES: INSTRUCCIONES
BEDIENUNGSANLEITUNG PARA EL USO

1) Hauptschalter 1) Interruptor general

2) Leuchtanzeige 2) Indicador luminoso
Kompressorbetrieb funcionamiento compresor

3) Taste 3) Botón disminución
Temperaturverminderung temperatura

4) Taste 4) Botón aumento
Temperaturerhöhung temperatura

5) Deckel 5) Tapa.

6) SET Taste 6) Interruptor SET

7) FN Taste 7) Interruptor FN

8) 8) Tapón de descarga de

Wasserablaufkappen

9) agua

Wasserablauf

1) Interruttore generale.

2) Indicatore funzionamento
compressore.

3) Tasto diminuzione
temperatura

4) Tasto aumento
temperatura

5) Coperchi.

6) Tasto SET

7) Tasto FN

8) Tappo scarico acqua

9) Scarico acqua

10) Descarga de agua

1) Interrupteur général

2) Voyant lumineux de
fonctionnement du
compresseur

3) Touche diminution de la
température

4) Touche augmentation
de la température

5) Couvercles

6) Touche SET

7) Touche FN

8) Bouchon de décharge
de l'eau.

10) Décharge de l’eau

Nemox International s.r.l. reserves the right to carry out all modifications which might be considered necessary.

Nemox International s.r.l. se réserve le droit d'apporter toute modification qui se rend nécessaire.

Nemox International s.r.l. se reserva el derecho de hacer toda modificaciòn que cree necesaria.

Nemox International s.r.l. si riserva il diritto di apportare tutte le modifiche ritenute necessarie.

Nemox International s.r.l. сохраняет за собой право на внесение необходимых поправок и изменений.

Nemox International s.r.l. hält das Recht alle notwendingen Aenderungen durchzufuehren.

Made in Italy by

|

3

English English

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be observed,
including the following:
Read all instructions carefully.
To protect against risk of electric shock, do not put the main body of appliance in water or
any other liquid.
This appliance has not been designed to be used by persons (including children) with
physical, sensory or mental impairments or who are lacking in experience or knowledge,
unless they have been given the necessary supervision and prior instructions about how
to use this appliance by a person responsible for their safety. Young children should be
supervised to ensure that they do not play with the appliance.
Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning.
Do not operate any appliance with a damaged cord or plug, or after the appliance
malfunctions, or is dropped or damaged in any manner. Return the appliance to an
authorized Service Center for examination, repair or electrical or mechanical adjustment.
The use of attachments not recommended or sold by the appliance manufacturer may
result in fire, electric shock or injury.
Do not let cord hang over edge of table or counter, or touch hot surfaces.

SAVE THESE INSTRUCTIONS

CAUTION

An authorized service representative should perform any servicing other than cleaning
and user maintenance. Repairs should only be carried out by authorised personnel.
Do not use in excessively damp places.
After removing the appliance from the packaging, check it for damage. If in doubt, do not
use the appliance and contact an authorised service centre.
Plastic bags, polystyrene, nails, etc. must not be left within reach of children as they are
potentially dangerous.
The appliance's manufacturer and vendor reject any responsibility for failure to comply
with the instructions provided in this user manual.
Check that the voltage shown on the rating plate corresponds to the voltage of the mains.
Never clean with scouring powders or hard implements.
Do not place or use the appliance on hot surfaces, such as stoves, hotplates, or near open
gas flames.
Do not unplug the unit by pulling on the cord.
The appliance must be connected to an electrical system and power supply socket with a
minimum capacity of 10A, equipped with an efficient earth contact. The manufacturer is
not responsible for damages to things or people in the event that the prescribed safety
norms have not been respected.
This appliance is suitable for use with 30°C max. ambient temperature (climatic class “4”).

IMPORTANT: this machine contains its own refrigerant which must be allowed to
settle after transport. Leave the machine on a plain surface for at least 12 hours
after purchase or after any move which might have stored the machine the wrong
way up.
Make sure the vent slots are free and unobstructed.

4

PRODUCT DESCRIPTION product.

Appliance to store at negative The compressor will start running again
temperature, fresh ice creams, sorbets and when the temperature in the storage unit is
foods suitable to be stored at the 2°C above that set.
temperature granted by this machine.
Storing temperature is regulated by an SETTING UP THE TEMPERATURE
electronic programmer. The temperature is selected by the
Technical data is reported on the plate on manufacture at -13°C.
the back of the device. How to change countertop temperature:

• Press SET button (6) twice.

INSTALLATION • Press button (3) to decrease and button

• Remove device from packaging. The (4) to increase the value. Variations can be
packaging materials must be disposed made within the limit of regulation range,
selectively on the basis of their between -8°C and -18°C.
composition. • Press button (6) once and wait for 15

• Place the device on a flat surface, away seconds; the new parameter will be stored
from heat and sunlight. Ensure that the in the memory and the electronic
ventilation grills are not obstructed. Leave programmer will back to indicate the
a minimum distance of 20 cm from walls or freezing cells temperature.
other surrounding objects. WARNING: this appliance is not suitable

• Clean the storage unit compartments and for freezing products but for keeping
the tubs with lukewarm water and neutral them frozen.
soap, using a non-abrasive sponge, and
dry with a soft cloth. For a proper ALARM FUNCTION
sanitization carefully follow the provisions This appliance has an alarm function.
of hygiene standards applicable in your When switched on, if the cellar is warm, the
country (HACCP or equivalent). countertop will automatically signal that the

• Clean the wood case with a soft cloth and temperature is over -7°C. Notice “Hit” will
a detergent suitable for cleaning of wooden blink on the display. Once reached
surfaces. operating temperature press button (7) as

long as the notice “Hit” will disappear from

USE the display. Notice “Hit” is shown every time

• Plug the device into a suitable electrical internal temperature of storing cellar
socket and turn on the master switch (1). increase over -7°C. Pression of button (7)

• The electronic thermoregulator will will deactivate notice “Hit” on the display,
display the compartments temperature but not the alarm function (which cannot be
and after few seconds will display the deactivated).
warning message “Hit” to indicate the
temperature too high inside the storage MAINTENANCE
cells. Press the key (7) on the electronic • Always proceed the cleaning operations
programmer to turn it off. after disconnecting the plug from the

• Compressor cooling system start electrical socket.
working. The light (2) on the left of the • Clean the wood case with a soft cloth and
display stays switch on during the whole a detergent suitable for cleaning of wooden
period the compressor is working. surfaces.

• The temperature will decrease • Clean the storage unit compartments and
progressively. Once reached the the tubs with lukewarm water and neutral
temperature selected, the compressor soap, using a non-abrasive sponge, and
stop and led (2) gets off. Wait for the dry with a soft cloth. For a proper

device to reach its operating sanitization carefully follow the provisions
temperature before introducing the of hygiene standards applicable in your

5

English

• Defrosting: IMPORTANT! The machine minutes may damage it permanently.
has to be manually defrosted. Compressor stay always switched on,

When ice formation on the walls exceeds a or it switch on and off frequently.
thickness of 0.5 cm, the storage unit should
be defrosted in order not to compromise
its thermal performance. Proceed as
follows:

• Remove the plug from the electrical
socket.

• Transfer the product to another suitable
device.

• Put a bin under the water drainage at the
bottom of the appliance (9).

• Leave out the caps (8) and let the internal
ice get melted: dry it up carefully.

• When the storage unit compartments are
completely dry, insert the plug into the

electrical socket.

• Wait for the device to reach its operating
temperature before replacing the ice

cream.

• Never use a metal or sharp object to
remove the ice: this might damage the
compartment.

• Efficiency. To maintain the device
efficiency operation, clean the condenser

• The room temperature is higher than
30°C.

• An excessive quantity of ice cream has
been put on the machine and the mass has

not yet reach the correct temperature.

• The ventilation grills do not have enough
space around it.

Vibrations.

• Check that the storage unit is level.

The storage unit makes too much noise.

• The noise may come from the circulation
of the refrigerant, which is normal.

• Contraction and expansion of the inner
walls may cause creaking.

• The storage unit is not in a leveLled
position.

The electronic programmer is not
running correctly.

• If the display show an error message
different from the warning described in this

manual, contact an Authorized Service

Centre.
regularly. This operation falls outside
normal maintenance and should be
performed by a qualified technician, who
should proceed as follows:

• Remove the plug from the electrical
socket.

• Clean the condenser with air jet or suction
device to avoid damaging the device.

• Restart the storage unit.

POSSIBLE PROBLEMS
The appliance is not running,
programmer is not light up.

• The plug has not been connected to
power supply socket.

• Main button is switched off.

The countertop is not running,
programmer is light up.

• The storage unit has been turned off and

you tried to restart it immediately. Try again
after at least 10 minutes. WARNING:
repeated turning on and off of the
compressor without a pause of at least 10

6