NEC PowerMate ES User Manual

409-00072-000 6/7/00 11:30 AM Page 1

PowerMate®ES Series System Board Configuration

Jumper Settings

USB Factory setting. Keyboard Disables system Wakeup wakeup by USB

JP2

3 2 1

keyboard.

Keyboard Factory setting. at Disables keyboard at power on. Power On

Save to Factory setting.

JP1

123

JP1

123

JP3

Enables keyboard at power on.

RAM Enables Suspend

mode Save to RAM (STR) function.

USB Port Factory setting. Selection Enables front

CMOS Factory setting. Maintains system board Clear configuration in CMOS RAM with onboard

JP13

321

USB port and

654

rear USB port.

JP19

1 2 3

battery.

JP19

Clears CMOS while system power is off.

1 2

Return jumper to pins 2 and 3 before

powering system on.

Caution: To prevent damage to the system board,

avoid clearing CMOS while power is on.

BIOS Factory setting. Sets the system for Recovery normal operation. The BIOS uses current

JP15

1 2 3

configuration information and passwords at power on.

To enable BIOS recovery for a corrupted system, remove the jumper. Wait 10 seconds. Replace the jumper on pins 1 and 2.

JP15

Restores Safe BIOS settings as the

1 2

default BIOS settings and loads the

BIOS Setup at power on.

JP2

Enables system

3 2

wakeup by USB

keyboard.

JP3

Disables Save to RAM function.

JP13

Disables front

321

USB port and enables rear

654

USB port.

Website: www.nec-computers.com Technical Support: 800-632-4525

Note: See your

PowerMate ES Series User’s Guide

for detailed option installation information.

Memory Upgrade

■

Maximum memory supported: 512 MB; minimum memory required: 32 MB.

■

Memory type and size can vary between sockets.

■

System supports 168-pin, 100-MHz non-ECC SDRAM modules in 32-MB, 64 -MB, 128-MB, and 256-MB configurations.

Use NEC memory upgrade kits for the best compatibility with your system. For memory compatibility information, call Technical Support.

■

Single- or double-sided DIMMS are supported.

■

No jumper setting required.

Processor Upgrade

See your user’s guide for detailed processor upgrade information.

JP2 Jumper

JP1 Jumper

System Memory Upgrade Sockets

JP3 Jumper

409-00072-000

JP15 Jumper

JP19 Jumper

PCI Slots

JP13 Jumper

Processor Socket 370

Primary

Secondary IDE Connector

IDE Connector