MTI MT-120018A User Manual

WIRELESS EDGE

BASE BRACKET INSTALLATION TO ANTENNA

Attach item 1 to the back of the antenna
using items 2,3,4 as shown.
Verify that the oriantation of the hole
in item 1 is alig ned with the elevation axis.
Use tightening torque of 5.7N/m.

1

RD42661500C/REV-A

X4 X4

1

2 3

X4

(MT-120018/A
ONLY)

For radio in 45

use this set of holes

x4

18

Attach item 1 to the back of the enclosure
using items2, 3, 13 as shown.
Verify that the oriantation of the hole
in item 1 is alig ned with the elevation axis.

ELEVATION

AXIS

Use tightening torque of 5.7N/m.

4

x4

2

3

x4

ELEVATION

AXIS

BASE BRACK ET INSTALLATION
TO ENCLOSURE

SHEET 2 OF 4

11 Hamelacha St. , Afek Industrial Park, Ro sh Ha’ayin 48091, Israel
Fax: [phone], Tel: [phone]
www.mtiwe.com

RD42661500C/REV-A

WIRELESS EDGE

INSTALLATION ON A POLE

Step 1
Connect the base bracket as shown on page 2.
Connect item 10 to item 1 (mate knurled
surfaces) using item 6,7,8,9 as shown.
Note: The bolt head shall be positioned in the
socket on item 1.
Use tightening torque of 24 N/m.

ANTENNA OR

RADIO ENCLOSURE

1

10

7 8 9

ANTENNA OR RADIO

ENCLOSURE

6

11

STEP 2 (FOR POLES SIZES 1.75"-3")
Install the antenna to the pole using item 11,
tighten the bracket using items 8,9,12 (for
small pole diameter use item 6 instead of item 12).
Use tightening torque of 14N/m.

x2

SHEET 3 OF 4

x2

6 or 12

8

x2

9

11 Hamelach a St. , Afek Industrial Park, R osh Ha’ayin 48091, Isr ael
Fax: [phone], Tel: [phone]
www.mtiwe.com