Mtd OEM-190-110 owners guide
Model Number
190-110-000
PRINTED IN U.S.A. FORM NO. 770-8358J
GRASS CATCHER
PARTS LIST FOR MODEL 110 GRASS CATCHER
REF. PART
NO. NO.
CODE DESCRIPTION
1 16839B Frame—Lower Ass’y.
2 747-0575 Frame—Upper
3 749-0774 Tube Support
4 764-0271 Grass Bag
5 710-0599 Hex Wash. Hd. TT-Tap
Scr. 1/4-20 x 5" Lg.
6 736-0270 Bell-Wash. 1/4" I.D.
8 747-0870 N Grass Bag Hook
9 710-0258 Hex Bolt 1/4-20 x .62" Lg.*
10 736-0329 L-Wash. 1/4" I.D.*
11 712-0287 Hex Nut 1/4-20 Thd.*
*For faster service obtain standard nuts, bolts and washers locally.
If these items cannot be obtained locally, order by part number
and size as shown on parts list.
HELPFUL OPERATING HINTS
When using the grass catcher, keep the engine
throttle in the “FAST” position so grass discharges
from the chute properly and completely fills the bag.
Always clean the grass catcher bag after use. Grass
remaining in the bag will cause mildew.
If any part of the grass catcher rubs against the
wheels, bend the catcher frame slightly to prevent
wear on the bag.
WARNING: Always stop the engine
before removing the grass catcher. Do
not restart the engine until the grass
catcher has been put back on the mower
in its proper place. Do not make any
adjustment to the grass catcher assembly while the blade is revolving.
NOTE: Under normal usage bag material is subject to
wear and should be checked periodically. Be sure any
replacement bag complies with the mower manufacturer’s recommendations. For replacement bags, use
only factory authorized replacement bag No. 764-
0271.
NOTE: Specifications subject to change without
notice or obligation.
A
E F G H I
B C D
Start
Here
WARNING: Never operate the mower with
the bag open.
TO ATTACH GRASS CATCHER TO MOWER
Side Discharge Mowers:
Raise the chute deflector on your mower. Slip the two
outside tabs on the grass catcher frame underneath
the hinge pin on the chute deflector as shown in figure
G. Release the chute deflector to lock the grass
catcher in position.
“3-in-1” Mowers:
Place the grass bag hook in position against the grass
catcher frame. Secure with 5/8" long hex bolt, lock
washer and hex nut. See figure H. Tighten securely.
Lift the mulching plug on your mower. Slide the grass
bag into position so the grass bag hook is inside the
two hooks on the mulching plug adapter plate. Lower
the mulching plug into operating position. See figure I.
TO REMOVE GRASS CATCHER
Lift the chute deflector (or mulching plug), and remove
grass catcher from the adapter plate. Carefully lower
the chute deflector (or mulching plug) into operating
position.
Empty the grass through the top opening on the grass
catcher. Be certain to close bag before reattaching to
mower.
ASSEMBLY INSTRUCTIONS
1. Attach the upper frame to the grass catcher bag
as follows.
a. Lay the grass bag so the black plastic side is to
the bottom.
b. Insert the long end of the upper frame into the
cloth channel in the grass bag, starting at the
point shown in figure A.
c. Feed all the material onto the long side of the
frame. See figure B.
d. Then insert the long end of the frame inside the
bag as you work the bag around the frame.
e. Insert the other end of the frame inside the
bag. See figure C.
2. Place one tube support inside the grass bag.
Insert one end of the upper frame into the tube
support. Tap on with a soft hammer or mallet.
Attach the other tube support in the same manner. See figure D.
3. Slide the ends of the lower frame assembly into
the tube supports as shown in figure E. Tap on
with a soft hammer or mallet if necessary.
4. Secure the bag to lower frame assembly as
shown in figure F by working the plastic channels
on bag over frame, starting with the bottom edge.
5. Place belleville washer onto self-tapping screw
(crowned side of washer goes against the head of
screw). Place screw through eyelet in grass bag.
Secure to lower frame as shown in illustration on
reverse side.
Side Discharge
Mowers
“3-in-1” Mowers “3-in-1” Mowers
Tabs
For Replacement Parts, Contact:
SERVICE DEPARTMENT •P.O. BOX 368022 •CLEVELAND, OHIO 44136-9722
6. Close the top of the bag by stretching the loose
material over the end of the frame.
Grass Bag
Hook
Hooks
Grass
Bag
Hook
Loading...