Mitsubishi LANCER EVOLUTION-VIII ELECTRICAL MANUAL

GENERAL - MODEL LINE-UP, APPLIED VEHICLES

00-1

SECTION 00

GENERAL

CONTENTS

Model line-up

Note
[] New model [] Continued model [X] Discontinued model

Applied vehicles

GH-CT9A: CT9A-0200001 ~

Model line-up..............................................1

Applied vehicle numbers ..........................1

Troubleshooting and Inspection ..............2

Model Version ’03 Model Grade Engine Model Transmission Fuel System
GH-CT9A SNDFZ

SYGFZ

SJDFZ
SJGFZ



X





RS
GT-A

RS
GSR

4G63
(2 000 DOHC 16 valve
intercooler turbo)

W5M51 (4WD, 5M/T)
W5A51 [4WD, INVECS-II

Sports mode 5 A/T (with
steering shift switch)

W6MAA (4WD, 6 M/T)

MPI

GENERAL - TROUBLESHOOTING AND INSPECTION

00-2

TROUBLESHOOTING AND INSPECTION

Diagnosis Functions

Reading Diagnosis Code

Connect the MUT-III to 16 pin diagnosis connector and read diagnosis code
as described below.
NB. Please refer to the User Manual for a detailed explanation of how to
use the MUT-III.
(1) Check that the ignition switch is in the LOCK (OFF) position.
(2) Connect special V.C.I. (MB991824) and PC with special USB cable

(MB991827).
(3) Connect special MUT-III main harness B (MB991911) to V.C.I.
(4) Connect MUT-III main harness B to vehicle diagnosis connector.
(5) Turn V.C.I. power switch ON.
(6) After switching V.C.I. ON, the green V.C.I. indicator light should come on.
(7) Start up the PC MUT-III system, and turn vehicle switch to the ON

position.
(8) Read diagnosis code.
(9) When disconnecting, turn ignition switch to LOCK (OFF) position, and

follow reverse procedure.

Diagnosis Code Deletion

Connect MUT-III to diagnosis connector in the same way as for ‘Reading
Diagnosis Codes’, then delete diagnosis codes.

MUT-III main harness B

USB cable

Diagnosis connector

MUT-III main harness B

USB cable

Diagnosis connector

V.C.I.

V.C.I.