TD 92578GB
2008-07-09/ Ver. A
Configuration Notes
Mitel ICP 3300 in Ascom VoWiFi System
1
1 Introduction
This document is merely intended as a guide when using a Mitel® IP Communications
Platform (ICP) 3300 in the Ascom VoWiFi System, and it does not by any means replace
the documentation delivered with the Mitel ICP 3300. The document describes some of
the settings needed to gain good performance when the Ascom VoWiFi Handset is used
together with the ICP 3300.
For maximum performance in the VoWiFi System consider the recommendations in the
document Considerations for Ascom VoWiFi System Planning, TD 92408GB.
The settings described in this document are extensions and apply for use with the Mitel
ICP 3300. For more information about Ascom VoWiFi System, see Function Description
VoWiFi System, TD 92314GB.
Note: The performance measurements are made with the Mitel ICP 3300 version 8 (might
apply for other versions as well).
1.1 Abbreviations and Glossary
2 VoWiFi Handset Configuration
Make sure the following parameters in the PDM correspond with the configuration of the
ICP 3300. The i75 should be configured as Multiline IP Set in the Mitel ICP 3300.
Select Protocols > General
Select Protocols > SIP
Select Device> User
ICP IP Communications Platform
PDM Portable Device Manager
SIP Session Initiation Protocol
Parameter Value Information
VoIP protocol “SIP”
Parameter Value Information
SIP proxy IP address ICP 3300 IP address
Secondary SIP proxy IP
address
Only used for redundant system
SIP proxy listening port 5060 (default value) Must correspond to the SIP port
used by the ICP 3300
SIP proxy ID ICP 3300 host name SIP Proxy IP address will be used if
present
SIP proxy password Multiline IP Set Login PIN
Hold on Transfer Enable "Hold on Transfer" must be enabled
for Mitel ICP 3300.
Parameter Value Information