Minoura P-60 User Manual

CC-100 “CLOSET-CYCLIST” instruction manual

Please read this instuctions carefully before use.

Thank you for purchasing Minoura CC-100 “Closet-Cyclist” bike
display stand.
This stand can hang off up to two bikes vertically in a narrow space,
so you can place this stand even in a closet in your room.

IMPORTANT NOTES

!

!

This stand requires some assembly . Y ou will need a M4 Hex wrench
and a 13 mm spanner in order to assemble Closet-Cyclist completely .

HOW TO ASSEMBLE YOUR CLOSET-CYCLIST

Screw the foot adjuster to the nut located on

1

each leg end.

This stand is designed for standard two wheel

bicycles. Do not use this stand for electric bikes

or tandems. The weight limit for two bikes is 50

kgs. or 110 lbs.

Make sure the stand is used on a level floor.

Failing to set-up and use this stand on a level

floor may cause the stand to fall over and cause

damage or injury.

Install the Reinforcement Arms between the Lower

3

Pillar and the Front Legs by tightening the M6x14

Insert four M8x55 bolts into the holes on the

2

bottom of the Lower Pillar, then put through
the legs. The long leg is for rear section, and
the short legs are for front section. Be sure to
fit the legs to the shape of the horrow of the
bottom plate.

Rear Leg

Front Leg

Lower Pillar

Bottom Plate

bolts for the pillar side, and M6x30 bolts for the
leg side. After installing the Reinforcement Arms,

(Fig. A)

tighten the M8x55 bolts firmly . W rong
step may make you unable to install
the Reinforcement Arms.

Reinforcement Arm

(Fig. B) (Fig.C)

Place the Connecting Plates at the top of the

4

Lower Pillar. Connect the Upper Pillar to the
lower pillar then tighten the M6x14 bolts
firmly. Now the base frame is completed.

Completed Closet-Cyclist

Upper Pillar

Connecting

Plate

Lower Pillar

Next, you'll install the Front Wheel Hook and

5

the Rear Wheel Support Arm to the pillar.
Disassemble the band clip (see Fig. E).
Wrap the stainless band around the pillar, in­sert the end of the band between another end
and the square nut.
Put the plastic bracket onto the band, attach
the hook or support arm, then tighten the bolt.

Stainless Band

Plastic Bracket

Install the Front Wheel Hook at the best height

6

for your bike on the Upper Pillar.
Install the Rear Wheel Support Arm on the
Lower Pillar. Make sure the bike is held se­curely.

Front Wheel Hook

(Fig. D)

(Fig. E)

FOR MORE INFORMATION

For parts or service outside of Japan or North

America, please consult your local shop or refer our

international distributor list (found on our web site)

for the distributor in your country.

MINOURA JAPAN

1197-1 Godo, Anpachi, Gifu 503-2305 Japan

Phone [phone]

Fax [phone]

Email : [e-mail]

http://www.minoura.jp

Rear Wheel Support Arm

(Fig. F)

MINOURA NORTH AMERICA

(for North American residents only)

1996 East Avenue, Hayward

CA 94541-5454 U.S.A.

Fax [phone]

Email : [e-mail]

MADE IN JAPAN

Copyright 2002 Minoura Co.,Ltd. All rights reserved