Minoura ACTION BRIDGE User Manual

ACTION BRIDGEInstruction manual

(Example: Action Bridge with Action Magroller)

Thank you very much for purchasing “ACTION BRIDGE”.
“ACTION BRIDGE” is a front fork support device which can be used for both previous model
“MagRoller II” and current model “Action MagRoller”.
As you know, triple roller trainer is the best indoor bicycle trainer to master smooth pedaling with
keeping correct position, but it may be difficult for the beginners to keep his balance on unstable
spinning rollers. Therefore we recommend that he should install “ACTION BRIDGE” to his
trainer. It holds his front fork firmly so that he will be able to train without helpers.
The unique urethane floating mounted front fork support system features quite convenient benefit
that avoiding any damages or troubles on front fork when ride hard.

IMPORTANT NOTES

• ACTION BRIDGE is the helper device for indoor bicycle training only. Don’t use
ACTION BRIDGE for other purposes.

• Read this instruction manual carefully before use. Always keep this manual beside
you.

• There are two different models of ACTION BRIDGE in the width of its frame; “Model­360” and “Model-450”.
Be sure Model-360 is for normal width (360mm) roller trainer only, and Model-450 is for
wider one (450mm) only.

• Check all bolts are tightened firmly before use. If you are noticed about cracks and/
or any troubles on ACTION BRIDGE, stop using immediately and contact to the dealer
you purchased.

RESOLUTION DIAGRAM

HOW TO INSTALL

First, cover both Fixing Plates from the outside of roller frame. Insert Knob Bolt through

1

the hole on the roller frame where the front roller can be installed, and then tighten with Sub
Fixing Plate temporarilly.

Place Frame Reinforcement Plates just on roller frame, and tighten them with Cap Bolts.

2

Frame Reinforcement Plate will disperse the load from the bike to roller frame and control
the movement of Frame, so that you should stick them onto roller frame.

Remove the front wheel from the bike, and fix the fork end onto Skewer.

3

You must tighten Skewer firmly in order to prevent from any troubles caused by looseness.

When you place the rear wheel between the center roller and rear roller, make sure that the

4

rear wheel touches to both rollers at same time.
When the rear wheel touches to only one roller even if you adjust the angle of Frame, your
install position is wrong. Install Knob Bolt again to the other hole.
Finally, tighten Knob Bolts firmly.

MORE INFORMATIONS

Contact: MINOURA CO.,LTD. JAPAN

1197-1 Godo Anpachi Gifu 503-23 JAPAN
Phone: [phone] / Fax: [phone]
E-mail: [e-mail] / [e-mail]