Miele K2901SF, F2901SF, F2911SF, K2911SF Specifications
Pre-finished
36” MasterCool II
K 2901 SF* / K 2911 SF*
F 2901 SF* / F 2911 SF*
KF 2901 SF / KF 2911 SF
KF 2981 SF
Shown: KF 2981 SF
Please note: This information is subject to
*The following models are not available in Canada : K 2901 SF, K 2911 SF, F 2901 SF & F 2911 SF
change
Specification Sheets TRS 04252019
8miele.ca
Pre-finished
36” MasterCool II
SPECIFICATIONS
Overall Unit Dimensions 353/4” (908 mm) W x 833/4”- 853/16” (2127 - 2164 mm) H x 24” (610 mm) D [Excludes Fascia Dimension]
Overall Fascia Dimensions 361/2” (927 mm) W x 84”- 8511/16” (2134 - 2175 mm) H x 11/2” (32 mm) D
Niche
Minimum Cabinet Niche Opening 36” (915 mm) W* x 84” - 853/16” (2134 - 2164 mm) H x 24” (610 mm) D
Interior Volume K 29x1 SF F 29x1 SF KF 29x1 SF
Refrigeration Volume ** 0 **
Freezer Volume 0 ** *
Electrical
Electrical Requirements
Power Cord NEMA 5-15 plug, 5 ft (1.52 m)
Plumbing K 29x1 SF F 29x1 SF KF 29x1 SF
Water Supply Requirements -
Water Connection Line
Shipping
Shipping Weight 483 lbs (219 kg) 495 lbs (225 kg) 588 lbs (267 kg)
Shipping Dimensions 40” (1016 mm) W x 8913/16” (1,294 mm) H x 291/4” (800 mm) D
Support
Call Miele
Miele Website
20/20 Link
Please note the following:
• This specication sheet is for a single built-in unit.
• When combining multiple MasterCool units side-by-side, please refer to the Merging Kit specication sheet.
*If design calls for a partition less than 6 5/16” (160 mm) the left unit’s cutout will require an additional 1/8” (3 mm) to the width to allow installation of
the Heating Mat/Merge Kit.
K 29x1 SF F 29x1 SF KF 29x1 SF
In the case of side-by-side installations, a separate outlet must be used for each appliance.
-
K 29x1 SF F 29x1 SF KF 29x1 SF
110V / 120V, 60Hz, 15 Amps
Connect to a cold water supply only. Do not connect to a low-mineral or
a reverse osmosis system. Must be connected to a shut-off valve. The
water shut-off valve must be accessible after installation. The water pressure must be between 29 psi (2 bar) and 116 psi (8 bar). If the pressure is
higher than 120 psi (8.3 bar), a pressure reducing valve must be installed.
Standard 1/4” O.D flexible water line. The maximum outer diameter of the
water pipe (without fittings): 3/8” (10 mm). Water line is not included.
(800) 565-6435
8www.miele.ca
82020technologies.com
K 2901 SF (Right Hinged)
K 2911 SF (Left Hinged)
F 2901 SF (Right Hinged)
F 2911 SF (Left Hinged)
KF 2901 SF (Right Hinged)
KF 2911 SF (Left Hinged)
KF 2981 SF (French Door)
Page 2 of 6
Loading...