Miele ESW 48XX EN-CA, ESW 47XX User Manual

Installation Instructions

ESW 47xx
ESW 48xx

en_CA

Installation, repair and maintenance work should be performed by

a Miele authorized service technician in accordance with national

and local safety regulations and the provided installation instructions.

CAUTION: Before servicing,

,

disconnect the power supply by
either removing the fuse, shutting off
the power main or manually
"tripping" the circuit breaker.

Electrical connection

Power supply

This appliance is equipped with a 5 ft
(1.5 m) long power cord with a
three-prong grounding plug ready for
connection to a 120 V, 15 A, 60 Hz
power supply.

Installation work and repairs should
only be performed by a qualified
technician in accordance with all
applicable codes and standards.
Repairs and service by unqualified
persons could be dangerous and
the manufacturer will not be held
responsible.

Before connecting the appliance to
the power supply, make sure that the
voltage and frequency listed on the
data plate correspond with the
household electrical supply. This
data must correspond to prevent
machine damage. Consult an
electrician if in doubt.

Only operate the warming drawer
after it has been installed into the
countertop.

Installer:
Please leave these instructions with
the consumer.

Further installation details are on the
wiring diagram.

25

Installation

Installation tips

– The warming drawer should be

placed at a convenient height for
easy access.

Steam from the vents can damage
the cabinetry surrounding the
warming drawer.

– The drawer should be installed clear

of drafts caused by open doors and
windows.

– Proper clearance must be allowed

for the warming drawer to open with
out interference.

– The warming drawer must be

secured to cabinetry to prevent the
drawer from tipping when loaded.

– The warming drawer should be level

to prevent the drawer from sliding
open or closing on its own.
The drawer cannot be leveled after it
has been installed.
If necessary install a shelf within the
cabinetry to support the drawer.

Solo Installation:

A minimum gap of 2" (5 cm) must be
present between the upper edge of
the warming drawer and the
cabinetry.

Installation in combination with an
oven:

A minimum gap of 1" (2.5 cm) must
be present between the upper edge
of the warming drawer and the oven.

This gap should be sealed with a
moisture resistant sealing material.

26

Dimensions for Solo Installation

ESW 47x0

Installation

a Material must be moisture resistant

Miele appliances can be installed ush or proud. Discuss your
installation requirements with you architect, designer and installer.

27