Microtek monitor Trouble-Shooting

Trouble-Shooting

If you are experiencing difficulties with your monitor, check the following table for possible solutions.

Problem Items to check

? No picture 1. The VGA card should be completely seated in the slot.

2. Power switch of the monitor and the PC should be in the ON position.

3. The signal cable should be completely connected to the video card / computer.

4. Check if the pins of the connector are bent or shrunk.

? Image is scrolling or unstable 1. The signal cable should be completely connected to the

computer.

2. Check the pin assignments and signal timings of the monitor and your video card.

? LED on the monitor is not lit 1. The adapter should be connected to DC Jack and AC outlet. ? Picture is fuzzy 1. Adjust the Dot Delay control or use Auto Tuning function. ? Picture bounces or wave pattern

is present in the picture

? Display image is not centered,

too small, or too large

1. Move electrical devices that may be causing electrical

interference away from the monitor.

2. Refer to the FCC information of this manual.

1. Adjust Size and Position Controls in the OSD or use Auto

tuning function.