Microsoft HS-128W Users Manual

HS-128W_en1_with_FCC&IC_notice.fm Page 1 Thursday, September 11, 2008 12:55 PM

Nokia Bluetooth Headset BH-606

1

2

3

4

5

7

6

8

9

10

11

12

9211748/1

HS-128W_en1_with_FCC&IC_notice.fm Page 2 Thursday, September 11, 2008 12:55 PM

ENGLISH

DECLARATION OF CONFORMITY

Hereby, NOKIA CORPORATION declares that
this HS-128W product is in compliance with
the essential requirements and other
relevant provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity can be
found at http://www.nokia.com/phones/
declaration_of_conformity/.

© 2008 Nokia. All rights reserved.
Nokia, Nokia Connecting People and the

Nokia Original Accessories logo are
trademarks or registered trademarks of
Nokia Corporation. Other product and
company names mentioned herein may be
trademarks or tradenames of their respective
owners.

Reproduction, transfer, distribution, or
storage of part or all of the contents in this
document in any form without the prior
written permission of Nokia is prohibited.

Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
Nokia operates a policy of ongoing
development. Nokia reserves the right to

make changes and improvements to any of
the products described in this document
without prior notice.

To the maximum extent permitted by
applicable law, under no circumstances shall
Nokia or any of its licensors be responsible
for any loss of data or income or any special,
incidental, consequential or indirect
damages howsoever caused.
The contents of this document are provided
"as is". Except as required by applicable law,
no warranties of any kind, either express or
implied, including, but not limited to, the
implied warranties of merchantability and
fitness for a particular purpose, are made in
relation to the accuracy, reliability or
contents of this document. Nokia reserves
the right to revise this document or
withdraw it at any time without prior notice.

The availability of particular products may
vary by region. Please check with your Nokia
dealer for details.

Export controls
This device may contain commodities,
technology or software subject to export
laws and regulations from the US and other

HS-128W_en1_with_FCC&IC_notice.fm Page 3 Thursday, September 11, 2008 12:55 PM

ENGLISH

countries. Diversion contrary to law is
prohibited.

Introduction

With the Nokia Bluetooth Headset
BH-606, you can make and receive
calls while on the move.

Read this user guide carefully before
using the headset. Also, read the user
guide for your phone. This product
may contain small parts. Keep them
out of the reach of small children.

Bluetooth wireless technology

Bluetooth wireless technology allows
you to connect compatible devices
without cables. The phone and the

headset do not need to be in line of
sight, but they should be within 10
metres (33 feet) of each other.
Connections may be subject to
interference from obstructions, such
as walls, or other electronic devices.

The headset is compliant with the
Bluetooth Specification 2.0 + EDR
supporting the Headset Profile 1.1 and
Hands-Free Profile 1.5. Check with the
manufacturers of other devices to
determine their compatibility with
this device.

Get started

The headset contains the following
parts shown on the title page: white
indicator light (1), earloop (2), volume

key (3), power key (4), answer/end key
(5), earpiece (6), charger connector
(7), and microphone (8).

HS-128W_en1_with_FCC&IC_notice.fm Page 4 Thursday, September 11, 2008 12:55 PM

ENGLISH

Before using the headset, you must
charge the battery and pair the
headset with a compatible phone.

Parts of the device are magnetic. Metallic
materials may be attracted to the device.
Do not place credit cards or other
magnetic storage media near the device,
because information stored on them may
be erased.

Charge the battery

Before charging the battery, carefully
read “Battery and charger
information”.

Warning: Use only chargers
approved by Nokia for use

with this particular model.
The use of any other types may invalidate
any approval or warranty, and may be
dangerous.

When you disconnect the power cord of
any accessory, grasp and pull the plug,
not the cord.

1. Connect the charger to a wall
outlet.

2. Connect the charger cable to the
charger connector. During
charging, the indicator light is on
and the headset cannot be used.
Charging the battery fully may take
up to 2 hours.

3. When the battery is fully charged,
the indicator light turns off.
Disconnect the charger from the
headset, then from the wall outlet.

If the headset was connected to

your phone before charging, the
headset connects to it again.

The fully charged battery has power
for up to 8 hours of talk time or up to
280 hours of standby time.

When the battery is discharged, the
headset beeps every minute and the
indicator light flashes quickly.

HS-128W_en1_with_FCC&IC_notice.fm Page 5 Thursday, September 11, 2008 12:55 PM

ENGLISH

Switch on or off

To switch on, press and hold the power
key for about 2 seconds. The headset
beeps, and the indicator light is
displayed. The headset tries to
connect to a paired phone.

To switch off, press and hold the
power key for about 2 seconds. The
headset beeps, and the indicator light
turns off.

Pair the headset

1. Ensure that your phone is on and
the headset is off.

2. Press and hold the power key (for
about 5 seconds) until the

indicator light starts to flash
quickly.

3. Activate the Bluetooth feature on
the phone, and set it to search for
Bluetooth devices.

4. Select the headset from the list of
found devices.

5. Enter the passcode 0000 to pair
and connect the headset to your
phone. In some phones, you may
need to make the connection
separately after pairing.

When the headset is connected to
your phone and is ready for use, the
indicator light flashes about every 5
seconds.

Basic use

Place the headset on the ear

Slide the earloop behind your ear, and
point the headset toward your mouth

(9 and 10). Gently push the earpiece
into your ear. To use the headset on

HS-128W_en1_with_FCC&IC_notice.fm Page 6 Thursday, September 11, 2008 12:55 PM

ENGLISH

the left ear, detach the earloop (11),
flip it, and push it into place (12).

Calls

To make a call, use your phone in the
normal way when the headset is
connected to it.

To redi al t he n umb er y ou la st c all ed (if
your phone supports this feature with
the headset), when no call is in
progress, press the answer/end key
twice.

To activate voice dialling (if your
phone supports this feature with the
headset), when no call is in progress,
press and hold the answer/end key for
about 2 seconds. Proceed as described
in the phone user guide.

To answer or end a call, press the
answer/end key. To reject a call, press
this key twice.

To set the headset volume, slide the
volume key up or down.

To mute or unmute the microphone
during a call, press the middle of the
volume key.

To switch a call between the headset
and a compatible phone, press and
hold the answer/end key (or the power
key) for about 2 seconds.

Handle two calls

To answer a waiting call and put the
active call on hold, press and hold the
answer/end key for about 2 seconds.

To answer a waiting call and end the
active call, press the answer/end key.

To end the active call and activate the
call on hold, press the answer/end key.

To switch between the active call and
the call on hold, press and hold the
answer/end key for about 2 seconds.

To use these features, your phone
must support the Bluetooth Hands­Free profile 1.5, and call waiting

HS-128W_en1_with_FCC&IC_notice.fm Page 7 Thursday, September 11, 2008 12:55 PM

ENGLISH

(network service) must be activated in
the phone.

Clear settings or reset

To delete the pairings from the
headset, switch off the headset, and
press and hold the power key and the
answer/end key for about 5 seconds.

To reset the headset if it stops
functioning, even though it is charged,
connect the headset to a charger that
is connected to a wall outlet.

Troubleshooting

If you cannot connect the headset to
your compatible phone, check that the
headset is charged, switched on, and
paired with the phone.

Battery and charger information

This device has an internal,
nonremovable, rechargeable battery. Do
not attempt to remove the battery from
the device as you may damage the
device. This device is intended for use
when supplied with power from the
following chargers: AC-3, AC-4, AC-5,
and DC-4. The exact charger model
number may vary depending on the type
of plug. The plug variant is identified by
one of the following: E, EB, X, AR, U, A, C,
or UB. The battery can be charged and

discharged hundreds of times, but it will
eventually wear out. Recharge your
battery only with Nokia approved
chargers designated for this device. Use
of an unapproved charger may present a
risk of fire, explosion, leakage, or other
hazard.

If a battery is being used for the first time
or if the battery has not been used for a
prolonged period, it may be necessary to
connect the charger, then disconnect and
reconnect it to begin charging the

HS-128W_en1_with_FCC&IC_notice.fm Page 8 Thursday, September 11, 2008 12:55 PM

ENGLISH

battery. If the battery is completely
discharged, it may take several minutes
before the charging indicator light is
displayed.

Unplug the charger from the electrical
plug and the device when not in use. Do
not leave a fully charged battery
connected to a charger, since
overcharging may shorten its lifetime. If
left unused, a fully charged battery will
lose its charge over time.

Always try to keep the battery between
15°C and 25°C (59°F and 77°F). Extreme
temperatures reduce the capacity and
lifetime of the battery. A device with a
hot or cold battery may not work
temporarily. Battery performance is

particularly limited in temperatures well
below freezing.

Do not dispose of batteries in a fire as
they may explode. Batteries may also
explode if damaged.

Never use any charger that is damaged.

Important: Battery talk and
standby times are estimates

only and depend on network
conditions, features used, battery age
and condition, temperatures to which
battery is exposed, and many other
factors. The amount of time a device is
used for calls will affect its standby time.
Likewise, the amount of time that the
device is turned on and in the standby
mode will affect its talk time.

Care and maintenance

Your device is a product of superior
design and craftsmanship and should be
treated with care. The following
suggestions will help you protect your
warranty coverage.

• Keep the device dry. Precipitation,

humidity, and all types of liquids or
moisture can contain minerals that
will corrode electronic circuits. If your

HS-128W_en1_with_FCC&IC_notice.fm Page 9 Thursday, September 11, 2008 12:55 PM

ENGLISH

device does get wet, allow it to dry
completely.

• Do not use or store the device in
dusty, dirty areas. Its moving parts
and electronic components can be
damaged.

• Do not store the device in hot areas.
High temperatures can shorten the
life of electronic devices, damage
batteries, and warp or melt certain
plastics.

• Do not store the device in cold areas.
When the device returns to its normal
temperature, moisture can form
inside the device and damage
electronic circuit boards.

• Do not attempt to open the device.

• Do not drop, knock, or shake the
device. Rough handling can break
internal circuit boards and fine
mechanics.

• Do not use harsh chemicals, cleaning
solvents, or strong detergents to
clean the device.

• Do not paint the device. Paint can
clog the moving parts and prevent
proper operation.

These suggestions apply equally to your
device, charger, or any accessory. If any
device is not working properly, take it to
the nearest authorised service facility for
service.

Disposal

The crossed-out wheeled-bin
symbol on your product,
literature, or packaging reminds

you that all electrical and
electronic products, batteries, and
accumulators must be taken to separate
collection at the end of their working life.
This requirement applies to the European
Union and other locations where
separate collection systems are available.
Do not dispose of these products as
unsorted municipal waste.

By returning the products to collection
you help prevent uncontrolled waste
disposal and promote the reuse of
material resources. More detailed

HS-128W_en1_with_FCC&IC_notice.fm Page 10 Thursday, September 11, 2008 12:55 PM

ENGLISH

information is available from the product
retailer, local waste authorities, national
producer responsibility organisations, or
your local Nokia representative. For the

product Eco-Declaration or instructions
for returning your obsolete product, go to
country-specific information at
www.nokia.com.

FCC/Industry Canada notice

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: 1. This device may not cause
harmful interference; and 2. This device
must accept any interference received,
including interference that may cause
undesired operation. This equipment has
been tested and found to comply with the
limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause

harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver. Connect the
equipment into an outlet on a circuit
different from that to which the receiver is
connected. Consult the dealer or an
experienced radio/TV technician for help.
NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This transmitter must not be
co-located or operating in conjunction with
any other antenna or transmitter. NOTE:
Changes or modifications not expressly

HS-128W_en1_with_FCC&IC_notice.fm Page 11 Thursday, September 11, 2008 12:55 PM

ENGLISH

approved by Nokia could void the user's
authority to operate the equipment.