Medion MD 30517 CODE LIST
1
1
7
7
I
I
N
N
C
C
H
H
L
L
C
C
D
D
C
C
OLL
O
O
O
R
R
M
M
O
O
NIITT
N
O
O
R
R
© 2005
All rights reserved.
This manual is protected by Copyright.
The Copyright is owned by Medion®.
Trademarks:
MS-DOS
Pentium
Other trademarks are the property of their respective owners.
Medion
not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Medion
ance, or use of this material.
Medion
This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Medion
The information in this document is subject to change without notice.
®
and Windows® are registered trademarks of Microsoft®.
®
is a registered trademark of Intel®.
®
makes no warranty of any kind with regard to this material, including, but
®
shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, perform-
®
assumes no responsibility for the use or reliability of its software on equipment that is not furnished by Medion®.
®
.
Contents:
SAFETY AND PRECAUTIONS...................................................................................................1
Operating Safety ...............................................................................................................1
Repair..............................................................................................................................1
Point of use ....................................................................................................................2
Intended Environment .....................................................................................................2
Connecting ..................................................................................................................... 2
Standards/Electro-Magnetic Compatibility ...........................................................................3
Precautions....................................................................................................................... 3
Recycling and Disposal ....................................................................................................... 3
FCC Compliance Statement............................................................................................... 4
Declaration of Conformity ................................................................................................. 4
INTRODUCTION ...................................................................................................................5
Notes on these instructions .................................................................................................5
Our Target Group ............................................................................................................5
Quality...........................................................................................................................5
Service .......................................................................................................................... 5
Included Equipment ...........................................................................................................5
Performance Characteristics ................................................................................................5
START-UP ...........................................................................................................................6
Preparations on Your Computer ...........................................................................................6
Supported Monitor Settings...............................................................................................6
Display Properties ...........................................................................................................6
Fixing the Monitor base ......................................................................................................8
Connecting the Monitor.......................................................................................................8
n Connecting VGA Signal Cable......................................................................................... 8
o Connecting Audio Cable ................................................................................................ 8
p Connecting the Power Supply ........................................................................................8
Positioning of the Monitor ................................................................................................... 9
Your posture................................................................................................................... 9
Working Ergonomics ...................................................................................................... 10
CONTROLS........................................................................................................................11
SETTING THE LCD MONITOR ............................................................................................... 11
OSD Menu (On screen display, all pictures similar) ............................................................... 11
Saving Energy................................................................................................................. 12
SERVICE........................................................................................................................... 13
Troubleshooting............................................................................................................... 13
Finding the problem....................................................................................................... 13
Troubleshooting ............................................................................................................ 13
Do you require additional support ?.................................................................................. 14
SPECIFICATIONS ............................................................................................................... 14
Guarantee ...................................................................................................................... 15
Liability limitations ........................................................................................................ 15
Copying this manual ...................................................................................................... 15
Pixel Defects on LCDs (TFT-Displays) ............................................................................... 16
Device
At the end of its life, the appliance must not be disposed of in household rubbish. Enquire about the options for
environmentally-friendly disposal.
ii
S
AAFFEETTYY AANNDD
S
Please read through this section carefully and follow the instructions given. In this way you will guarantee reliable operation and a long life for your LCD monitor. Always keep these instructions handy
and close by your LCD monitor. Keep the instructions and the packaging so that if you sell or give
away your LCD monitor you can give them to the new owner.
P
RREECCAAUUTTIIOONNS
P
S
OPERATING SAFETY
• Never open the housing of the LCD monitor! When the housing is open there is a
danger of injury from electric shock, short-circuit and the danger of fire!
• Do not insert any objects through the slots and openings into the inside of the LCD.
This may lead to an electrical short-circuit or even fire resulting in damage to your LCD
monitor (electrical shock, short-circuit and the danger of fire)!
• Slots and openings in the LCD monitor are for ventilation purpose. Do not cover these
openings, as otherwise this may lead to overheating (overheating, danger of fire)!
• Do not allow children to play unattended on electrical equipment. Children may not always
correctly recognize danger.
• This LCD monitor is intended for personal use only. It not intended for commercial use in a
heavy industry environment. Operation under extreme environmental conditions can result in
damage to your device.
• An injury hazard exists when the display breaks. Wear protective gloves to pack the broken parts
and send them into your service center for proper disposal. Then wash your hands with soap, be-
cause it is possible for chemicals to escape.
• Never exert pressure on the display. This could break the monitor.
• Do not touch the display with your fingers or with sharp objects to avoid damage.
Switch off your appliance immediately or do not switch it on at all and contact customer
service …
• … if the power cord or the connectors attached to it are burnt or damaged. Replace the defec-
tive power cord with an original power cord. Under no circumstances may a defective power
cord be repaired.
... if the housing of the PC is damaged or fluids have leaked into it. Have the PC checked by
customer service first, because the PC may not be safely operated otherwise and there may
be a life-threatening risk of electrocution!
REPAIR
• Leave all repairs of your LCD monitor to authorized and qualified personnel only.
• Should a repair be necessary, please contact one of our authorized service partners only.
S
AAFFEETTYY AANNDD
S
P
RREECCAAUUTTIIOONNS
P
S
1
POINT OF USE
• Keep your LCD monitor and all units connected to it away from moisture and avoid dust, heat and
direct sunlight. Failure to observe these instructions can lead to malfunctions or damage to the LCD
monitor.
• Do not place any containers filled with liquid (vases or similar containers) on the device.
The container could tip over and liquid can impair electrical safety.
• Do not place any open sources of fire (candles or similar objects) on the device.
• Pay attention to sufficiently large clearances in the wall cupboard. Maintain a minimum
clearance of 10 cm around the device for sufficient ventilation.
• Place and operate all units on a stable, level and vibration-free surface in order to avoid the
LCD monitor from falling.
• Avoid dazzle, reflections, extreme light/dark contrast in order to save your eyes and
ensure a pleasant, ergonometric work station.
• Take regulator breaks when working with your LCD monitor in order to avoid tension and
fatigue.
INTENDED ENVIRONMENT
• The LCD monitor can be operated at an ambient temperatures of between +41°F and +95°F
(5° C to 35° C) and at a relative humidity of between 20% and 85% (without condensation).
• When switched off, the monitor can be stored at between -4°F and +140°F (-20° C - +60° C), up to
the maximum height of 39,000 ft (12,000 m) above sea level at a relative humidity of between 20%
and 80% (without condensation).
• After transporting your LCD monitor please wait until it has assumed the ambient temperature
before connecting and switching it on. Extremely high variations in the temperature or humid-
ity may result in condensation forming on the inside of the LCD monitor which could cause an
electrical short-circuit.
CONNECTING
Observe the following instructions to connect your LCD monitor properly:
POWER SUPPLY
• Please pay attention: Pats of the device are still live, even if the mains switch is
switched off. Pull the mains plug out of the socket, to interrupt the power supply to
your LCD monitor or to release the device from voltage completely.
• Operate your LCD monitor mains (power supply) only on grounded sockets with AC 100-240V~/ 50-
60 Hz. If you are not sure about the power supply at your location, check with your power company.
• For additional safety we recommend use of an excessive voltage protection device to protect
your LCD monitor from damage resulting from voltage surges or lightning.
• To interrupt the LCD monitor from mains (power supply) disconnect the plug from the socket.
• The power socket must be in the vicinity of your LCD monitor and within reach of the power ca-
bles. DO NOT stretch the power cables tightly to reach a power socket.
• If you use an extension cable, ensure that it fulfills the VDE requirements. Please ask your
electrician.
• You should lay the LCD Monitor cables in a manner that no one can trip or step on it.
• To avoid damage of cable do not place any objects or furniture on the cable.
• Your device has an On and Off switch. The LCD monitor can be switched on or off by means of it.
No electricity is consumed if the switch is at OFF (0).
2
E
E
NNGGLLIISSH
H
STANDARDS/ELECTRO-MAGNETIC COMPATIBILITY
Your monitor fulfils the requirements for electro-magnetic compatibility and electrical safety specified in the
following standards:
EN 55022
Information technology equipment - Radio disturbance characteristics - Limits
and methods of measurement.
EN 55024
EN 60950
Information technology equipment - Immunity characteristics - Limits and methods of measurement.
Safety of information technology equipment.
• Provide an interval of at least one meter from high-frequency and magnetic sources of interference
(television sets, loudspeakers, mobile telephones, etc.) in order to avoid malfunctions and data loss
.
• The failure of individual or groups of luminous points can arise in rare cases, in spite of the most
up-to-date manufacture, because of the highly complex technology.
Your device corresponds to the ISO 13406-2 Class II (Pixel Error Class) European Norm (see page 16).
PRECAUTIONS
 Caution! There are no parts which can be serviced or cleaned inside of the moni-
tor housing.
You can increase the service life of your LCD monitor by taking the following precautions:
• Before cleaning always disconnect the power line and all connection cables.
• Do not use any solvents, caustic or gaseous cleaning agents.
• Clean the display with a soft, lent-free cloth.
• Ensure that no water droplets remain on the screen. Water can cause permanent
discoloration.
• Do not expose the screen to bright sunlight or ultraviolet radiation.
• Please keep the packaging material safely and use it exclusively to transport the monitor.
RECYCLING AND DISPOSAL
This appliance and its packaging was produced mostly from materials which can be disposed of in an
environmentally friendly manner and be professionally recycled. After its use the computer will be
taken back and recycled or use will be made of its useful material, if it is returned in a condition corresponding to its intended use. Parts not usable will be properly disposed of.
Should you have any questions concerning the disposal please contact your dealer or our service.
S
AAFFEETTYY AANNDD
S
P
RREECCAAUUTTIIOONNS
P
S
3
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment. Shielded interface cables, if any, must be used in order
to comply with the emission limits.
DECLARATION OF CONFORMITY
According to 47CFR, Parts 2 and 15 for
We: Medion Aktiengesellschaft____________
(Name of the Responsible Party)
Located at: Gänsemarkt 16 – 18_________________
D-45127 Essen_____________________
Germany__________________________
(Address, City, State, Zip Code)
Fax : 0 201 / 81 081 – 227____
(Facsimile Number for conformity issues only
Declare under sole responsibility that the product identified herein, complies with 47CFR Parts 2 and 15 of the FCC rules as a
Class B digital device. Each product marketed, is identical to the representative unit tested and found to be compliant with
the standards. Records maintained continue to reflect the equipment being produced can be expected to be within the variation accepted, due to quantity production and testing on a statistical basis as required by 47CFR §2.909. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation. The above named party is responsible for
ensuring that the equipment complies with the standards of 47CFR §§15.101 to 15.109.
Trade Name: Medion
Type or
Model Number: MD 30517
Party Responsible: MEDION AG
Executed on (Date), at (Place): 11
h
of November, 2005, Essen
Class B Personal Computers:
)
4
NNGGLLIISSH
H
E
E
Loading...