V oltage on any Pin Relativ e to VSSVIN-0.3V to 4.3V
Ambient Operating TemperatureT opr0°C to 70°C
Storage T emperatureTstg-65°C to 125°C
Note:Minimum DC voltage on input or I/O pins is -0.5V. During voltage transitions, inputs ma y undershoot VSS to
-1.3V for periods of up to 20ns. Maximum DC voltage on input or I/O pins is VCC+0.5V. During voltage
transitions, input may ov ershoot VCC to VCC+2.0V for periods of up to 20ns.
DC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 3.0V~3.6V)
ItemSymbolMIN.MAX.Conditions
Output High VoltageVOH2.4V-IOH = -400uA
Output Low VoltageVOL-0.4VIOL = 1.6mA
Input High VoltageVIH2.2VVCC+0.3V*MAX. number:VCC+0.3V is
under normal operation mode,
and VCC+0.7V is under
non-operating mode
Input Low VoltageVIL-0.3V0.2 x VCC
Input Leakage CurrentILI-5uA0V, VCC
Output Leakage CurrentILO-5uA0V , VCC
Operating CurrentICC1-25mAtRC = 120ns, all output open
Standby Current (TTL)ISTB1-0.5mACE = VIH
Standby Current (cmos)ISTB2-15uACE>VCC-0.2V
Input CapacitanceCIN-10pFTa = 25°C, f = 1MHZ
Output CapacitanceCOUT-10pFTa = 25°C, f = 1MHZ
AC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 3.0V~3.6V)
Read Cycle TimetRC70ns-90ns-100ns -120ns-150ns Address Access TimetAA-70ns-90ns-100ns-120ns-150ns
Chip Enable Access Time tACE-70ns-90ns-100ns-120ns-150ns
Output Enable TimetOE-35ns-45ns-50ns-60ns-70ns
Output Hold After Address tOH0ns-0ns-0ns-0ns-0nsOutput High Z DelaytHZ-20ns-20ns-20ns-20ns-20ns
Note:Output high-impedance delay (tHZ) is measured
from OE or CE going high, and this parameter guaranteed by design over the full voltage and temperature
operating range - not tested.
P/N:PM0243
3
REV. 2.5, AUG. 15, 2001
AC T est Conditions
Input Pulse Levels0.4V~ 2.4V
Input Rise and Fall Times10ns
Input Timing Level1.4V
Output Timing Level1.4V
Output LoadSee Figure
TIMING DIAGRAM
MX23L1610
IOH (load)=-0.4mA
DOUT
IOL (load)=1.6mA
Note:
No output loading is present in tester load board.
Active loading is used and under software programming control.
Output loading capacitance includes load board's and all stray capacitance.