V oltage on any Pin Relativ e to VSSVIN-0.8V to VCC+2.0V (Note)
Ambient Operating TemperatureT opr0°C to 70°C
Storage T emperatureTstg-65°C to 125°C
Note: Minimum DC v oltage on input or I/O pins is -0.5V. During voltage transitions, inputs may undershoot VSS to -0.8V
for periods of up to 20ns. Maximum DC v oltage on input or I/
O pins is VCC+0.5V. During voltage transitions, input may
overshoot VCC to VCC+2.0V for periods of up to 20ns.
DC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 5V±10%)
ItemSymbolMIN.MAX.Conditions
Output High VoltageVOH2.4V-IOH = -1.0mA
Output Low VoltageVOL-0.4VIOL = 2.1mA
Input High VoltageVIH2.2VVCC+0.3V
Input Low VoltageVIL-0.3V0.8V
Input Leakage CurrentILI-5uA0V, VCC
Output Leakage CurrentILO-5uA0V, VCC
Operating CurrentICC1-70mAf=5MHz, all output open
Standby Current (TTL)ISTB1-1mACE = VIH
Standby Current (cmos)ISTB2-100uACE>VCC-0.2V
Input CapacitanceCIN-10pFTa = 25°C, f = 1MHZ
Output CapacitanceCOUT-10pFTa = 25°C, f = 1MHZ
AC CHARACTERISTICS (Ta = 0°C ~ 70°C, VCC = 5V±10%)
ItemSymbol 23C6410-10 23C6410-12 23C6410-15
MIN.MAX.MIN.MAX.MIN.MAX.
Read Cycle Timet RC100ns-120ns-150ns Address Access TimetAA-100ns-120ns-150ns
Chip Enable Access TimetACE-100ns-120ns-150ns
Output Enable TimetOE-50ns-60ns-70ns
Output Hold After AddresstOH0ns-0ns-0nsOutput High Z Delayt HZ-20ns-20ns-20ns
Note:Output high-impedance delay (tHZ) is measured from
OE or CE going high, and this parameter guaranteed by design over the full voltage and temperature operating range not tested.
P/N:PM0406
3
REV. 2.7, JAN. 15, 2002
AC T est Conditions
Input Pulse Levels0.4V~ 2.4V
Input Rise and Fall Times10ns
Input Timing Level1.4V
Output Timing Le v el0.8V and 2.0V
Output LoadSee Figure
TIMING DIAGRAM
RANDOM READ
MX23C6410
IOH (load)=-1mA
DOUT
IOL (load)=2.1mA
Note:No output loading is present in tester load board.
Active loading is used and under software programming control.
Output loading capacitance includes load board's and all stray capacitance.