Installation & Operations Manual for
BMG-HGP & BMG-SLP Model
Bottom Mounted Full-Length Glass Door
Refrigerator Merchandisers
Sollatek controller Rev. 08-09-13
2
TABLE OF CONTENTS
INTRODUCTION . . 4
STORE CONDITIONS . . ..... .4
WARNING LABELS AND SAFETY INSTRUCTIONS ......5
PRE-INSTALLATION INSTRUCTIONS .... .................... 6
Inspection for Shipping Damage . .6
INSTALLATION INSTRUCTIONS . 6
General Instructions ...6
Mechanical ... ..6
Electrical.... ..7
Temperature Control . . ..7
Leg..... ..8
Doors.. ........8
Grill .. ........8
SERVICE INSTRUCTIONS . 9
TEMPERATURE CONTROL AND FAN MOTOR REPLACEMENT . 10 FINAL CHECK LIST . . 10 PARTS LIST...11 ACCESSORIES . ...11 SALE AND DISPOSAL .12
WIRING DIAGRAM . ... 13-14
3
INTRODUCTION
This manual contains important instructions for installing, using, and servicing a BMG-Plus included with this manual. Read all these documents carefully before installing or servicing your
case. A parts list is equipment.
STORE CONDITIONS
The BMG-Plus cases are designed to operate in the controlled environment of an air-conditioned store. The store temperature should be at or below 75°F and a relative humidity of 55% or less. At higher temperature or humidity conditions, the performance of these cases may be affected and the capacity diminished.
The BMG-Plus should not be positioned where it is directly exposed to rays of sun or near a direct source of radiant heat or airflow. This will adversely affect the case and will result in poor performance.
If this case is to be located against a wall, there should be at least 4” space between the wall and the back of the case. This space will allow for the circulation of air behind the case, which will prevent condensation on the exterior surfaces.
NOTICE
Read this manual before installing your cabinet. Keep the manual and refer to it before doing any service on the equipment. Failure to do so could result in personal injury or damage to the cabinet.
DANGER
Improper or faulty hook-up of electrical components on the refrigeration units can result in severe injury or death.
All electrical wiring hook-ups must be done in accordance with all applicable local, regional or national standards.
NOTICE
Installation and service of the refrigeration and electrical components of the cabinet must be performed by a refrigeration mechanic and/or a licensed electrician.
The portions of this manual covering refrigeration and electrical components contain technical instructions intended only for persons qualified to perform refrigeration and electrical work.
This manual cannot cover every installation, use or service situation. If you need additional information, call or write Customer Service Department.
4
WARNING LABELS AND SAFETY INSTRUCTIONS
This symbol is the safety-alert symbol. When you see this symbol on your cabinet or in this manual, be alert to the potential for personal injury or damage to your equipment.
Be sure you understand all safety messages and always follow recommended precautions and safe operating practices.
NOTICE TO EMPLOYERS
You must make sure that everyone who installs, uses or services your cabinet is thoroughly familiar with all safety information and procedures.
Important safety information is presented in this section and throughout the manual. The following signal words are used in the warnings and safety messages:
DANGER: Severe injury or death will occur if you ignore the message.
WARNING: Severe injury or death can occur if you ignore the message.
CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.
NOTICE: This is important installation, operation or service information. If you ignore the message, you may damage your cabinet.
The warning and safety labels shown throughout this manual are placed on your cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800) 684-8988 for replacements.
This label is located on top of the electrical control label and on the wiring channel.
CAUTION!
GROUND REQUIRED
FOR SAFE OPERATION
This label is attached to the cabinet power cord on models with a power cord.
5
Loading...