Marmitek MS8000 User Manual

SECURITY SYSTEM WITH BUILT-IN TELEPHONE DIALLER

HOMEGUARD MS8000

option KR21

art. no. 09169

OWNER’S MANUAL 2

2 MARMITEK - NICOSHOP

1. SAFETY PRECAUTIONS:

a. HomeGuard is designed for indoor use only. b. Use HomeGuard only in dry places c. The supplied power adapter is designed for use

for 230V only

d. Do not open the power adapter, as there is

dangerous voltage inside. No serviceable parts are located inside.

e. In case of any need for service, contact your

nearest Marmitek Authorised Service Centre (MASC).

f. The built -in siren generates an extremely high

noise level that may harm you if you are too close! Never put your ears close to the HomeGuard.

2. IMPORTANT FUNCTIONS AND CONTROLS:

1. Keyboard:

Open the cover by pulling the upper part forward.

2. Passive Infrared Sensor (PIR):

Detects motion within a range of 12 meters and an opening angle of 110˚.

3. Siren:

Built-in 90dB siren is triggered by an alarm and can

be switched of (silent alarm) via the keyboard after entering your personal access code (PIN).

4. Battery compartment:

Contains a back-up battery in case of a power failure or tampering. For longer back up times a 9V alkaline (approx.10h) or Lithium battery (approx. 30h) can be used. Battery lifetime is reduced each time the power is switched off or the power adapter is disconnected from mains. If the HomeGuard is disconnected from mains for a longer period of time on purpose, remove the battery first.

5. Status indicators:

red: • burns continuously when the alarm

is activated.

green: • flashes when the device is being

programmed.

• flashes when the device is being turned on (time delay).

• burns continuously when the device is on.

6. Telephone input:

Connects the HomeGuard to the public telephone network with the supplied cable.

7. Power supply:

Only use the supplied 12V power adapter.

8. External alarm contact:

This input allows you to connect any external alarm device with a non-powered NO (Normally Open) or NC (Normally Closed) contact. E.g. smoke alarms, magnetic door/window contacts, flood and temperature detectors, etc. You may connect multiple devices in series to the HomeGuard. This allows you to turn your HomeGuard into a complete security system with built-in telephone dialler. To connect any external security device, use the supplied cable with mini-plug or install an equivalent jack plug on these devices.

3. WIRELESS KEY FOB REMOTE CONTROL KR21 (OPTION)

ARM: Will put the HomeGuard into the armed position.

The alarm is instant or delayed. Delayed arming allows you to leave the room within 30 seconds or enter the room and switch off the alarm within 15 seconds after entering. The factory default is instant arming (no delay). To change this setting please refer to Delayed Arm (7). DISARM: Switches off and resets the HomeGuard. PANIC: If pressed simultaneously will cause an alarm instantly. Lights On/Lights Off: These buttons are not used with HomeGuard.

Indicator flashes if remote transmits a command. If indicator does not flash or lights up weakly, replace the batteries. The battery holder is located inside the remote. The back of the remote can be easily opened using your fingernails or a small screwdriver. Only use 3V lithium batteries model CR2016. Push the ARM key for more than 3 seconds and release the button; the indicator blinks. If batteries are replaced, you’ve to reregister with the base station (refer to installation).

SELECTING A SUITABLE LOCATION

The base station has a so-called passive infrared element that detects any change in temperature within its range. A certain amount of heat related to human beings is detected for an alarm. However to achieve the best performance of your HomeGuard, note following installation recommendations before installing:

a. It should be located at approx. 170-180cm

height on a fixed vertical surface e.g. wall or cupboard

b. Choose a location where an intruder may pass

the monitored area at all time in an early stage of intrusion.

c. Choose a location near to a wall outlet and tele-

phone socket.

HOMEGUARD MS8000 3

3 3

+ 5 hidden pages