SERVICE BULLETIN
Date: 27-Feb.-2004 Model: DV8400
Page: 1 /1 REF.NBR: MZ04-017
Subject:
Circulation: Application:
x for information customer
complaint in case of service
mandatory
...................
[PHENOMENON]
1) FRONT L/R 1 2 and SURR.L/R, CENTER L/R, SUB W L/R of AUDIO OUTPUT are simultaneously
Connected to amplifier.
2) If the Amplifier which used the electronic switch is turned off, another sound will be distorted.
[REASONS]
FRONT L/R 1 2 are connected parallel, therefore, if the Amplifier input of another side short-circuits,
it will influence
[SOLUTION]
On the PM01-AV CIRCUIT BOAD
1. Resistor 1k ohm is added to 2 of FRONT L/R 1 2.
2. Cut pattern.
See Below
Int.ref:
Output signal distortion.
Solder side of FRONT L/R 1 2 (Jack RCA)
[NECESSARY PART]
Carbon film fixed resistor,1k ohm +-5% 1/6W (part no.
[REMARKS]
GD05102160
1 k ohm
Cut pattern
)
The countermeasure apply to this claim only.
Approved by S.NAGAO Written by
WQ-19 2 817
/additional rule 3 (1st Issue 2003-03-19)
Date:
15-May-2003
Model DV8400
Page:1/1 REF.NBR:MZ03-016
SERVICE BULLETIN
Subject:
Circulation: Application:
1. Slow mode problem
x for information
customer complaint
in case of service
mandatory
Before
MZxxxxxx02xxxx
2. RC232C command problem in the condition of
“No Disc.”
Int.ref:
[ PHENOMENON]
1. Can not change the slow speed or not engaged to the slow mode in the condition of “5.1ch mode” and
TruSurround “ON” mode of the Set Up MENU.
2. The Status of the RC232C will be “PLAY” in the condition of “No Disc” and send the “PLAY” command from
RS232C.
3. The status of the RC232C will be “TRK” in the condition of “No Disc” and with tray open/close or turned on
power.
[SOLUTION]
Replace the Front MPU (QF01) to the new one. (Parts No. *HS11AKT2R)
[REMARKS]
This improvement has been done in the production after Lot number “03” and later.
The Lot number is mentioned the serial number label on the rear panel.
(ex.
MZxxxxxx03xxxx
)
Approved by H.Tamura Written by K.ONO
WQ-19 2 817
/additional rule3 (1st Issue 2003-03-19)