Makita UMLOOOD, UMLOOODW User Manual
m
100
100
mm
mm
(4")
(4")
MODEL UMlOOOD
MODEL UMlOOODW
With Fast Charger
INSTRUCTION MANUAL
SPEC
IF
I
CAT
IONS
Model
UMlOOOD
Effective cutting
100
Battery
Cartridge
Voltage
72v
x
Manufacturer reserves the right to change specifications without notice
*
Note: Specifications may differ from country to country.
mm
14")
width
7000
Strokes
Charging
1
per
min
1,000
*
time
Hr
Dimensions
320
112-5/8" x 4" x 4 114")
Model
DC7100
A.C
only
mm
x
Fast
input
50
100
Charger
Hr
IL
x W x
mm
~ 60
x
108
Hr
HI
mm
Net
1
kg
output
DC
weight
12
2
lbsl
72V
IMPORTANT
SAFETY INSTRUCTIONS
(For
All
Tools)
WARNING:
TY PRECAUTIONS SHOULD ALWAYS
WHEN USING ELECTRIC TOOLS, BASIC SAFE-
BE
FOLLOWED TO
REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PERSONAL INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1.
Be aware that this appliance is always in an operating condition, because
it
does not have to be plugged into an electrical outlet.
2.
Avoid Dangerous Environment
cations.
3.
Don't Use In Rain.
4.
Keep Children Away
area.
5.
Dress Properly
in moving parts. Use of rubber gloves and substantial footwear is recommended when working outdoors.
6.
Use Right Appliance
it
which
7.
Avoid Unintentional Starting
8.
Don't grasp the exposed cutting blades or cutting edges when picking up
or holding the appliance.
9.
Don't Force Appliance
of a risk of injury at the rate for which
IO.
Don't Overreach
11.
Store Idle Appliances Indoors
stored indoors in dry, high or locked-up place
12.
Maintain Appliance With Care
best performance and to reduce the risk of injury. Follow instructions for
lubricating and changing accessories.
is intended.
-
All visitors should be kept at a distance from work
-
Do not wear loose clothing or jewelry. They can be caught
-
-
-
Keep proper footing and balance at all times.
-
Don't use appliances in damp or wet
Do
not use appliance for any job except that for
-
Don't carry appliance with finger on switch.
It
will do the job better and with less likelihood
it
was designed.
-
When not in use, appliances should be
-
out of reach of children.
-
Keep cutting edge sharp and clean for
lo-
2
IMPORTANT SAFETY INSTRUCTIONS
1.
SAVE THESE INSTRUCTIONS
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
(1)
battery charger,
on
3.
CAUTION - To reduce risk of injury, charge only MAKITA Battery
Other types of batteries may burst causing personal injury and damage.
4.
Do
not expose charger to rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result
6.
To reduce risk of damage to electric plug and cord,
cord when disconnecting charger.
7.
Make sure cord is located
otherwise subjected to damage or stress.
8.
An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result
extension cord must be used, make sure:
a.
That pins on plug of extension cord are the same number, size, and shape
as those of plug on charger;
b. That extension cord is properly wired and
c. That wire size is at least as large as the one specified in the table below.
(2)
battery, and
in
a risk of fire, electric shock, or injury to persons.
so
that
(3)
product using battery.
pull
it
will
not be stepped on, tripped over, or
in
a risk of fire and electric shock. If
in
good electrical condition; and
-
This manual
7000.
by plug rather than
TABLE
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS
Length of Cord (Feet)
AWG Size of Cord
9.
Do
not operate charger
mediately.
IO.
Do
not operate charger if
wise damaged
11.
Do not disassemble charger or battery cartridge; take
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12.
To
reduce risk of electric shock, unplug charger from outlet before attempt-
ing
any maintenance or cleaning. Turning off controls
in
any way; take
with
damaged cord or plug - replace them im-
it
has received a sharp blow, been dropped, or other-
it
1
FOR
BATTERY CHARGERS
25 50
18 18
to a qualified serviceman.
100 150
18 16
it
will
not reduce this risk.
to a qualified
3
ADDITIONAL SAFETY RULES
FOR CHARGER
1.
Do
not charge Battery Cartridge when temperature is BELOW 10°C (5OOF)
4OoC
or ABOVE
2.
Do not attempt to use a step-up transformer, an engine generator or DC power
receptacle.
3.
Do
not allow anything to cover
4.
Do not short the battery cartridge:
(1)
Do not touch the terminals
(2)
Avoid storing battery cartridge
as nails, coins, etc.
(3)
Do not expose battery cartridge to water or rain.
A battery short can cause a large current
and even a breakdown.
5.
Do
not store the tool and Battery Cartridge in locations where the tempera-
ture may reach or exceed 5OoC (122OF).
6.
Do
not incinerate the Battery Cartridge even if
completely worn out. The battery cartridge can explode
(104OF).
&
BATTERY CARTRIDGE
or
clog the charger vents.
with
any conductive material.
in
a container
with
other metal objects such
flow,
overheating, possible burns
it
is severely damaged or is
in
a fire.
SAVE THESE INSTRUCTIONS.
4
Loading...