LT Security PTZ217X12 Installation Manual

4-inch Speed Dome

Installation Manual

V1.0.0

Installation Manual of 4-inch Speed Dome

1

Thank you for purchasing our product. If there is any question or request, please do not hesitate to
contact the dealer.
This manual is applicable to 4-inch Speed Domes.
This manual may contain several technically inaccurate points or printing errors, and the content is
subject to change without notice. The updates will be added into the new version of this manual.
We will readily improve or update the products or procedures described in the manual.

Installation Manual of 4-inch Speed Dome

2

Regulatory Information

FCC Information
FCC compliance: This equipment has been tested and found to comply with the limits for a digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.

FCC Conditions

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause
undesired operation.

EU Conformity Statement

This product and - if applicable - the supplied accessories too are marked with "CE"
and comply therefore with the applicable harmonized European standards listed
under the Low Voltage Directive 2006/95/EC, the EMC Directive 2004/108/EC.

2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of
as unsorted municipal waste in the European Union. For proper recycling, return this
product to your local supplier upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more information see:

www.recyclethis.info.

2006/66/EC (battery directive): This product contains a battery that cannot be
disposed of as unsorted municipal waste in the European Union. See the product
documentation for specific battery information. The battery is marked with this

symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury
(Hg). For proper recycling, return the battery to your supplier or to a designated collection point. For
more information see: www.recyclethis.info.

Installation Manual of 4-inch Speed Dome

3

Safety Warnings and Cautions

Please pay attention to the following warnings and cautions:

Hazardous Voltage may be present: Special measures and precautions must be

taken when using this device. Some potentials (voltages) on the device may
present a hazard to the user. This device should only be used by employees from
our company with knowledge and training in working with these types of devices
that contain live circuits.

Power Supply Hazardous Voltage: AC mains voltages are present within the power supply assembly.
This device must be connected to a UL approved, completely enclosed power supply, of the proper
rated voltage and current. No user serviceable parts inside the power supply.

System Grounding (Earthing): To avoid shock, ensure that all AC wiring is not exposed and that the
earth grounding is maintained. Ensure that any equipment to which this device will be attached is
also connected to properly wired grounded receptacles and are approved medical devices.

Power Connect and Disconnect:The AC power supply cord is the main disconnect
device to mains (AC power).The socket outlet shall be installed near the equipment
and shall be readily accessible.
Installation and Maintenance:Do not connect/disconnect any cables to or perform

installation/maintenance on this device during an electrical storm.

Installation Manual of 4-inch Speed Dome

4

Power Cord Requirements: The connector that plugs into the wall outlet must be a grounding-type

male plug designed for use in your region. It must have certification marks showing certification by
an agency in your region. The connector that plugs into the AC receptacle on the power supply must
be an IEC 320, sheet C13, female connector. See the following website for more information

http://kropla.com/electric2.htm.

Lithium Battery: This device contains a Lithium Battery. There is a risk of
explosion if the battery is replaced by an incorrect type. Dispose of used

batteries according to the vendor’s instructions and in accordance with local

environmental regulations.
Perchlorate Material: Special handling may apply. See

www.dtsc.ca.gov/hazardouswaste/perchlorate. This notice is required by California Code of

Regulations, Title 22, Division 4.5, Chapter 33: Best Management Practices for Perchlorate Materials.
This device includes a battery which contains perchlorate material.

Taiwan battery recycling:

Please recycle batteries.

Thermal and Mechanical Injury:Some components such as heat sinks, power
regulators, and processors may be hot; care should be taken to avoid contact
with these components.

Electro Magnetic Interference:This equipment has not been tested for

compliance with emissions limits of FCC and similar international regulations. This device is not, and
may not be, offered for sale or lease, or sold, or leased until authorization from the United States
FCC or its equivalent in other countries has been obtained. Use of this equipment in a residential
location is prohibited. This equipment generates, uses and can radiate radio frequency energy which
may result in harmful interference to radio communications. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment on
and off, the user is required to take measures to eliminate the interference or discontinue the use of
this equipment.

Lead Content:

Please recycle this device in a responsible manner. Refer to local
environmental regulations for proper recycling; do not dispose of device in
unsorted municipal waste.

Installation Manual of 4-inch Speed Dome

5

Warnings:

Follow these safeguards to prevent
serious injury or death.

Cautions:

Follow these precautions to
prevent potential injury or
material damage.

Safety Instruction

These instructions are intended to ensure that user can use the product correctly to avoid danger or
property loss. The precaution measure is divided into Warnings and Cautions:

Warnings: Neglecting any of the warnings may cause serious injury or death.
Cautions: Neglecting any of the cautions may cause injury or equipment damage.

Warnings

 In the use of the product, you must be strict compliance with the electrical safety regulations of

the nation and region.

 Please use the power adapter, which is provided by normal company. The standard of the power

adapter is AC24V/3A.

 Do not connect several devices to one power adapter as adapter overload may cause over-heat

or fire hazard.

 Please make sure that the plug is firmly connected on the power socket.
 When the product is installed on wall or ceiling, the device shall be firmly fixed.
 If smoke, odors or noise rise from the device, turn off the power at once and unplug the power

cable, and then please contact the service center.

 If the product does not work properly, please contact your dealer or the nearest service center.

Never attempt to disassemble the camera yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)

Cautions

 Do not drop the dome or subject it to physical shock, and do not expose it to high

electromagnetism radiation. Avoid the equipment installation on vibrations surface or places
subject to shock (ignorance can cause equipment damage).

 Do not place the dome in extremely hot, cold (the operating temperature shall be -30°C ~ +65°C),

dusty or damp locations, or fire or electrical shock will occur otherwise.

 The dome cover for indoor use shall be kept from rain and moisture.
 Exposing the equipment to direct sun light, low ventilation or heat source such as heater or

radiator is forbidden (ignorance can cause fire danger).

 Do not aim the camera at the sun or extra bright places. A blooming or smear may occur

otherwise (which is not a malfunction however), and affecting the endurance of CCD at the
same time.

Installation Manual of 4-inch Speed Dome

6

 Please use the provided glove when open up the dome cover, avoid direct contact with the

dome cover, because the acidic sweat of the fingers may erode the surface coating of the dome
cover.

 Please use a soft and dry cloth when clean inside and outside surfaces of the dome cover, do not

use alkaline detergents.

Installation Manual of 4-inch Speed Dome

7

Preparation for Installation

 Basic requirements.

 All the electronic operation should be strictly compliance with the electrical safety

regulations, fire prevention regulations and other related regulations in your local region.

 Check whether all the accessories are included according to the packing list, make sure that

the installation place and mode conform to the demands. If not, please contact the supplier.

 Please use this product according to the requirement of working environment.

 Check installation space.

Make sure the place have enough space to install the speed domes and its accessories.

 Check the intensity of conformation at the installation location.

Please make sure that the ceilings or walls are strong enough to withstand four times the weight
of speed dome and its accessories.

 Preparation of cables.

 Choose the video cable according to the transmission distance. The video should meet the

least demands as: 75Ω resistance; 100% copper core conducting wire; 95% weaving copper
shield.

 RS485 communication cable, please refer to Appendix 2
 24V AC power cable, please refer to Appendix 3

 Please keep all wrappers.

Please keep all wrappers after unpack them for future use. In case of any failure occurred, you
need to return the speed dome to the factory with the original wrapper.

Note: Transportation without the original wrapper may result in damage on the speed dome

and lead to additional costs.

Installation Manual of 4-inch Speed Dome

8

Table of Contents

Chapter 1 Installation............................................................................................................................................ 1

1.1 Installation and Cabling ........................................................................................................................................ 1

1.1.1 Installing the Speed Dome ............................................................................................................................... 1

1.1.2 Connecting the Cables ..................................................................................................................................... 6

1.2 DIP Switch Settings ............................................................................................................................................... 7

1.2.1 Address Settings ............................................................................................................................................... 8

1.2.2 Baudrate Settings ........................................................................................................................................... 10

1.2.3 Protocol Settings ............................................................................................................................................ 10

1.3 Alarm In/Out Connections ................................................................................................................................. 10

Chapter 2 Mount Introduction ............................................................................................................................. 12

2.1 Wall Mount ........................................................................................................................................................ 12

2.2 Pendant Mount .................................................................................................................................................. 13

Chapter 3 Mounting Applications ........................................................................................................................ 14

3.1 Wall Mounting .................................................................................................................................................... 14

3.2 Pendant Mounting ............................................................................................................................................. 16

3.3 In-ceiling Mounting ............................................................................................................................................ 18

Appendix ..................................................................................................................................................................... 23

Appendix 1 Lightning & Surge Protection ....................................................................................................................... 23

Appendix 2 RS485 Bus Connection ................................................................................................................................. 24

Appendix 3 24VAC Wire Gauge & Transmission Distance .............................................................................................. 26

Appendix 4 Wire Gauge Standards ................................................................................................................................. 27

Installation Manual of 4-inch Speed Dome

1

Lower Dome

Three Screws

Chapter 1 Installation

Before you start:

Check the package contents and make sure that the device in the package is in good condition and
all the assembly parts are included.

1.1 Installation and Cabling

1.1.1 Installing the Speed Dome

There are several ways to install the analog speed dome or network speed dome. The ceiling
mounting is taken as an example below. Please refer to the Chapter 2 and Chapter 3 for other
installation ways.

Steps:

1. Loosen three screws as shown in the following figure.

2. Remove the lower dome.

3. Loosen three screws which are used to secure the camera module with the back box as shown

4. Remove the back box from the camera module.

Figure 1-1 Remove the Lower Dome

in the following figure.

Installation Manual of 4-inch Speed Dome

2

Back Box

Three Screws

Camera Module

Dome Liner

Figure 1-2 Remove the Back Box

5. Secure the ceiling mount to the ceiling.

1) Stick the drill template on the place where you want to install the speed dome.

2) Drill three φ6 screw holes with the drill template as shown in Figure 1-4.

Figure 1-3 Camera Module

Installation Manual of 4-inch Speed Dome

3

Drill Template

Φ6 Screw Hole

Figure 1-4 Drill Template

6. Secure the back box to the ceiling with screws as shown in Figure 1-5.

Figure 1-5 Install the Ceiling Mount

Notes:

 For cement ceiling mounting, you need to use the expansion screw to fix the mount. The

mounting hole of the expansion pipe on the wall should align with the mounting hole on the
mount.

 For wooden ceiling mounting, you can just use the self-tapping screw to fix the bracket.